资源列表
si4463-RXTX
- MSP430单片机+SI4463射频芯片开发，无线发送、接收驱动函数源码。(msp430 and SI4463 project development,willess tx and rx drivers.)
DO-178C_ED-12C
- DO-178C, Software Considerations in Airborne Systems and Equipment Certification is the title of the recently published document RTCA, Incorporated, in a joint effort with EUROCAE. This replaces DO-178B as the primary document by which the certifica
cc2530-Temp.-and-Hum.-Sensor
- 这是CC2530 zigbee模块关于温湿度传感器DHT11 实验的资料 -代码复制到IDE仿真即可(This is the CC2530 zigbee module DHT11 experiments on temperature and humidity sensor data - code can be copied to the IDE emulation)
trx_si446x
- 基于si446X无线收发代码. 实现数据在1G以下频率的传送和接收(TRX function base on the si4463)
nrf24l01-to24le1
- nrf24l01与nrf24le1的通讯(send and receive between nrf24l01 and nrf24le1.)
RC500-sch-PCB
- RC500原理图和天线图, 天线是不好设计的,但是包里面有现成的, 可以直接用(RC500 schematic and the antenna, the antenna is a bad design, but the package inside the off-the-shelf, can be directly used)
pynfc-0.0.4
- python写的NFC应用，可用于手机和移动智能设备。(NFC protocol by python)
leach
- 无线传感网络很好的节能算法，适合开发者研读(Good energy saving wireless sensor network algorithm for developers to read)
SPWM
- spwm正弦表有很多，但不知怎样调用它，有了这个脉宽计算器 直接调用，不同的定时器频率生成不同的spwm 还附带有定时器周期设置计算值，对正弦波开发很有帮助 (SPWM sine table has a lot of, but I do not know what to call it, the pulse width calculator direct calls, timer frequency of different generation of the SPWM also comes w
SS628-100SDK
- 神思SS628-100开发包SDK,神思二代证阅读器的第三方软件接口开发包。(Spiritual SS628-100 development kit SDK, Meditation second generation ID card reader interface to third-party software development kit.)
IRcontrolmenu
- 红外遥控控制数码管显示可调菜单程序 1、程序说明： 该例程演示了利用红外遥控控制数码管显示可调整菜单，菜单的内容为假设 设置一组电机的参数。 2、实验操作 1、将跳线插座J9的跳到DIR端。 操作： 按键："2"键：设置，"1"键：加，"3"键：减，"5"键：确定 按下按键 "2"键 进入设置，数码管高四位显示菜单，低四位显示菜单参数。 依次按"2"键将显示下一个设置量。 设置的内容顺序依次
DAC0832
- 信号发生器 可生成阶梯波 方波 三角波 正弦波 频率和幅度可调 1602显示 proteus+C51源码(Jie Tibo can generate triangular square wave sine wave Adjustable frequency and magnitude 1602 display Proteus+C51 source code)