资源列表
单片机上网卡演示用HEX程序
- 单片机上网卡演示用HEX程序 -SCM 72.16 procedures used to demonstrate HEX SCM 72.16 procedures used to demonstrate HEX
12mjmjaa
- at89C2051驱动步进电机的原理图和源码-at89C2051 stepper motor drives the schematic and source
mjmjaaa001
- 一个ADC0809和DAC0832的程序-a ADC0809 and procedures DAC0832
mjmjmjaa002
- 用c51编写写的x25045的读写程序，-used to prepare written procedures x25045 reader,
mjmjmjaaa003
- 最新10位数字温度传感器AD7416驱动程序-latest digital temperature sensor AD7416 driver
用AT89C2051设计超声波测距仪
- 本文介绍了AT89C2051单片机的性能和特点，并在分析了超声波测距原理的基本系统框图。该设计系统经校正后，其测量精度可达0.1米-This paper introduces the AT89C2051 performance and features, and the analysis of the ultrasonic distance measurement principle diagram of the basic system. The design of the system ca
bigTime
- dsp 5509a 的usb程序ATMEGA16单片机进行AD转换的源程序代码-dsp 5509a the usb procedures ATMEGA16 microcontroller for AD conversion of the source code
remote
- ht47r20遥控程序，红外线载波输出频率这系统时钟的12分频，当系统频率为480KHZ，载波频率为40KHZ-ht47r20 remote control procedures, infrared output carrier frequency system clock frequency of 12 minutes, when the system frequency for 480KHZ, carrier frequency 40KHZ
平缝机控制代码
- 平缝机的单片机伺服控制系统源代码。本程序为用单片机控制永磁同步电机的低成本方案-sewing machine SCM servo control system source code. The procedures for the use of SCM control PMSM low-cost programs
mytcp
- 我自己写的一个tcp/ip的代码，很短，用的是vc来做模拟调试的，具体的运行是要在mcs51单片机上的，只有一个端口。具体请大家看程序吧！-I wrote it myself a tcp / ip code, in a very short, it was vc do simulation testing, the specific operation is to mcs51 MCU, only one port. Please refer to specific procedures!
用单片机设计频率计
- 单片机为控制器件的，一个小巧的频率测试器。用c语言编写，用过验证和实际实践。-microcontroller for the control device, a compact frequency device. C language with the preparation, certification and used actual practice.
S52的midi演示
- 一个用s52单片机，制作 的一个音乐产生试验电路，和 相关 源代码。可供大学单片机试验课参考-presentation with a microcontroller, the production of a music test circuit, and associated source code. SCM Test for University Course reference