资源列表
code
- 基于51单片机两相四线步进电机驱动程序，本程序可用42，57系列步进电机，工作方式为八拍。(Based on 51 single-chip two phase four line stepping motor driver, this program can use 42, 57 series of stepper motor, working mode is eight.)
9 RSSI值测距离
- 1.CC2530F256测距，使用Zigbee协议栈开发，精度为小数点后1位，主程序入口提供详细文档解析，采用广播的方式组网，目前组网3个没问题，上位机串口调试助手显示距离； 2.协议栈使用rssi来计算距离，测量范围在0.1~3m区间误差不到百分之3； 3.如需定位，简单修改主函数套公式即可； 4.程序使用ZStack-CC2530-2.3.1-1.4.0。(1.CC2530F256 ranging, using Zigbee protocol stack development, ha
自用SHT10-20-30驱动
- 自己项目上用的 SHT102030温湿度传感器51驱动，完全可用，共享给大家使用！(The SHT102030 temperature and humidity sensor 51 driven on its own project is fully available and shared to you.)
基本完成版(SPI)
- 详细介绍了LDC1000的使用及STM32的程序(LDC1000 use was introduced in detail and the STM32 program)
SIM900A模块上传数据至onenet例程
- GPRS模块上传到onenet平台驱动程序(The GPRS module is uploaded to the onenet platform driver)
xianh
- 用的是HT66F002单片机，C语言编写，通过对38K红外遥控解码，点亮一个指示灯(Infrared remote control decode, light a light)
VB上位机通信例程资源帖大集合
- vb与单片机串口通讯，vb上位机通讯例子资源大集合。。(Serial communication between VB and single chip microcomputer)
IAP15W4K58S4_4串口通信
- STC15系列单片机4串口通信程序。操作寄存器，并非用库，简洁明了(STC15 Series MCU 4 serial communication program. The operation register, not using the library, is concise and clear)
STM32频率测试程序
- stm32通过定时器捕获模式测量信号频率并通过LCD屏幕显示(STM32 measurement of signal frequency)
侧幅度_频率程序
- 基于msp430f5529的测频和测幅度(Frequency measurement)
MentorKG.v11.4
- MENTOR GRAPHICS KEYGEN
新概念51单片机—配套电子书
- 入门51单片机的利器,详细介绍单片机的构造跟应用，加入的代码例子可以使小白迅速掌握51单片机(Introduction to the 51 MCU, a detailed introduction to the construction and application of SCM. The code example can make newer quickly grasp the 51 single chip microcomputer.)