资源列表
stm32-Frequency-meter
- 使用stm32通用计数器做的一个简易频率计，可以算出脉冲宽度还有其占空比-Done using a general-purpose counter stm32 simple frequency counter, you can calculate the pulse width as well as its duty cycle
OLED
- 51单片机驱动 OLED 程序, Protues 仿真-51 MCU OLED driver program ,Protues simulation
mcp4261main
- 数字电位器4261m控制程序 spi通信模式-Digital Potentiometers control procedures 4261m communication mode spi
tempure-control
- 空调房间温湿度控制(温度控制模型),含: 房间模型,蒸发器模型,加热器模型,加湿器模型-Air-conditioned room temperature and humidity control (temperature control model)
qiyaji
- 89C52基于MPX4105的数字气压计设计，里面有原理图和代码-89C52-based MPX4105 Digital Pressure Gauge Design, which are schematic and code
oled
- SSD1322核心的OLED液晶初始化以及简单显示的例程-SSD1322 core OLED LCD display routines to initialize and simple
CAN
- STM8S208单片机 can口驱动程序-STM8S208 can port driver
Study_IR_Remote_Control
- 资料包含源码，硬件图，红外相关资料等，本学习型红外遥控器，通过学习一次遥控器的编码，即可脱离原遥控器来遥控电器或者设备，源码很完整，严格测试过，不过由于C52的单片机RAM有限，编码缓冲区长度有限，而不同的遥控器的编码长度也不相同，对于像空调遥控器编码比较长的就会出现学习不了的情况，必须要加外部RAM作为接收缓冲区，或者换用STC的单片机，内部的RAM比较大，不用扩展，用STC还有好处就是不需要外部的eeprom来保存读取的编码，而C52需要用外部的EEPROM来保存编码，这个源码实用的AT24
CodeCharger
- 共享我自制的充电器程序，此程序可以控制我的四节电池充电， 内部算法适用于小容量的锂电池充电-I share my home-made charger program, this program can control my four batteries, the internal algorithm is suitable for small-capacity rechargeable lithium battery
MX25L1605D
- 之前自己找了很久MX25L1605D的驱动程序，但一直没找到，这个是自己根据资料写出来的，方便大家用到这个片子的，此驱动已经用在产品中了-MX25L1605D your own for a long time before the driver, but could not find, this is based on information written by himself, to facilitate this film we use, this drive has been used
Flyback_UC3842
- 基于MULTISIM和uc3842的反激式升压开关电源的仿真-MULTISIM and uc3842 based flyback step-up switching power supply simulation
s12x_demo_CW
- SIMULINK BLOCKSET FOR FREESACLE S12X