资源列表
uartprogramm
- 在数据格式给定的前提下，进行串口中断通信，同时纠正数据的错误格式-data format to the premise, interrupt communications, while correcting the erroneous data format
RC_filter
- 计算RC（阻容）滤波时间常数的程序，有两种单位制，适合matlab65环境运行。 -calculated RC (R) filter time constant of the process, there are two unit system, matlab65 environment suitable for running.
wri2c
- I2C程序,自己写的一个I2C读写程序，用了好长时间，还行-I2C procedures themselves have written an I2C literacy program, for a long time, OK
DoZLG7289
- 读写zlg7289的程序，C语言写的，有些函数据已用过，有的是新写的-literacy zlg7289 procedures, written in C, according to some function has been used, some new writing.
writeRead8563
- 读写PCF8563的C源程序，已测试过,可以使用-literacy PCF8563 C source code, test that can be used
eightinterrupt
- 这是一个八路循环的模拟电压转换电路,将模拟信号在数码管上显示出来-This a cycle of eight-way analogue voltage conversion circuit, the analog signal in the digital show the tube!
C_mod
- 本资料文件讲述了如何将TC的程序移植到嵌入式系统中，附带核心代码-the information document on how to TC transplant procedures to embedded system, the core code fringe
clok
- 一个非常简单的而又实用的电子时钟，是用51单片机写ASM原代码-a very simple and practical electronic clock, using a 51 MCU write ASM source code
SQCOMM51
- 51串行令牌格式 a51编译 Read data from serial port and write into buffer DPTR pointed in XRAM if a data frame is received and calculate the check sum if a information frame is received return control byte only -51 serial format A51 compile
juzhenjieshou
- 说明在程序里，里面包括了串口，X5045,定时器程序。-note of the proceedings, including the inside of the serial, X5045, timers procedures.
sy08
- 1． 掌握压控振荡器的基本原理和调试方法。 二． 实验原理 压控振荡器，顾名思义，其输出频率随输入电压的改变而变化。它大致可分为两类，一类是调谐式，另一类是多谐式。多谐式一般线性好，但输出不是正弦波，只能通过间接方式获得。振荡频率一般较低。调谐式多用于发射机中，一般高频电子线性课程会有介绍。 这里介绍两种压控振荡器及其常用电路类型，供大家参考 -1. VCO master the basic principles and debugging methods. 2. VCO exp
mcupp
- mcu51程序串口输入控制2相4线步进电机的程序，可用撒法-mcu51 procedures serial input control two phase 4-wire stepper motor procedures available Sheva