资源列表
串口通讯演示程序
- 此程序为单片机开发过程中的串口通信演示程序。用 汇编编写，供参考。-procedure for microcontroller development process of serial communications demonstration program. Using a compilation prepared for reference.
电磁炉控制
- 压缩文件包括电磁炉的控制程序和其原理电路图！方便大家阅读程序，配合原理图阅读！-compressed files including Induction Cooker control procedures and its tenets circuit! To facilitate reading the procedure to incorporate the diagram read!
7301code
- 一个多媒体液晶显示器内部控制器(主芯片为:7301)的源程序(KC51-an internal multimedia LCD Controller (Controller chip : 7301) of the source (KC51
AN011
- 如何在5V系统中使用C8051FXXX，通过实例具体介绍了其应用。-5V system in use C8051FXXX, through specific examples of its application.
LPC900_SPI
- LPC900单片机与SPI互为主从模式详解，及其C语言程序。-LPC900 SCM and SPI mainly from mutual understandings mode, and C language programming.
51单片机系统中运用电脑上的大键盘
- 51单片机系统中运用电脑上的大键盘！ Keyboard接线 PS/2--------51 1 DATA------P3.4 3 GND 4 VCC 5 CLK-------P3.3 接在51的外部中断，触发方式为低电平 AT89x51使用12M Modified by Shen Peng! Postgraduate of 2003, 7 Department Harbin Engineering University-51 microcomputer system on the use of t
200505060050419
- 十字路*通灯管理现对交通信号灯进行管理，车行道的黄灯闪烁5秒钟后，转为人行横道行人放行1分钟，然后再转为车行道车辆放行3分钟。如此循环重复。 用发光二极管模拟信号灯，8255A实现对信号灯的控制（所用端口自定），8253的计数器2定时向实验系统主片8259A的IRQ7请求中断，以实现3分钟，5秒钟和1分钟的定时。 实验系统8253计数器2的CLK2可接OPCLK，频率为1.19318MHZ，GATE2已接＋5V，定时可采用软硬件结合相结合的方式实现。-traffic lights at a c
BC7281A中断方式代码
- 可驱动8/16位数码管显示或64/128只独立LED 的芯片BC72811A中断编程。BC7281A只占用单片机3个I/O口-can drive 8 / 16 Digital Display or 64/128 only independent LED chip BC72811A interrupted programming. BC7281A only occupies three microcontroller I / O port
SERIAL_80C552.
- 飞利浦的80C552串口通信代码，可通过PC机完成对单片机的控制，并向上位机返回数据。-80C552 bunches of communication code of Philip, can finish the control on one-chip computer through the PC , and return to the data in the upward location machine.
PDIUSBD12固件源码
- 修改后的PDIUSBD12完整固件源码，实现51单片机的USB接口，完全通过测试。-revised PDIUSBD12 integrity of the firmware source code, achieving 51 SCM's USB port and fully tested.
drv_nandflash
- drive for nandflash on sansung corp.
C汇编的上电初始化
- 单片机C语言的上电初始化，这确实是个头疼的问题!-microcontroller on the C language -- initialization, it is indeed a headache!