资源列表
motion_test
- CODESYS Motion控制程序，控制比例阀(CODESYS Motion control program, control proportional valve)
基于STM32简易电机伺服控制器
- 基于stm32的伺服驱动，可以控制4个电机(Servo drive based on stm32)
STC12C5A60S2 电压电流表
- 基于STC12C5A60S2实现电压电流测量，diy 电压电流表(Realization of voltage and current measurement based on STC12C5A60S2, DIY voltage ammeter)
BS8XXXX_LIB_V302_20121212
- 合泰触摸IC驱动程序，验证测试，可以用，单片机C语言(Holtek touch IC driver test, can use microcontroller C language)
16f73逆变器
- 通过PIC16F73单极性做PWM控制作逆变器(By PIC16F73 unipolar, PWM control is used as inverter)
CanOpen
- canopen主站模板，从站模板，源码注释，资料(CANopen templates, source notes, information)
US100&sr06热卖超声波资料
- //TDC中断输出脚，此脚用要来内配己完成信息的中断提示 //中断引脚Pin8,INT可以有不同的中断源，在寄存器2的Bits29-31（EN_INT）以及寄存器6 //bit 21位中进行选择. //Reg 2 bit 29 = 1 ALU 已经准备好 //Reg 2 bit 30 = 1 被设置的脉冲个数全部被接收到 //Reg 2 bit 31 = 1 TDC 测量单元溢出 //Reg 6 bit 21 = 1 EEPROM 动作的结束 //如果需要两个或两个以上的中断源，可
D1223
- 太阳能控制器Microcontroller to do solar controller(Microcontroller to do solar controller)
STM32F0.hlb.l01
- STM32F030芯片，多路通道ADC采样，串口收发函数，定时器定时(STM32F030 chip, multi-channel ADC sampling, serial transceiver function, timer timing)
QML智能家居
- QML智能家居系统代码， 主要由Qt的QML语言写成；主要由欢迎界面、房间选择界面、灯光控制、窗帘控制、环境控制等界面构成.。(QML smart home system code, mainly written by Qt QML language; mainly by the welcome interface, room selection interface, lighting control, curtain control, environmental control interfa
IAP_BootLaoder
- 通过Ymodem 协议 使用串口实现IAP(IAP BOOTLOADER ymodem)
HX711驱动
- keil5编写的基于STM32F103T8的模拟HX711驱动程序(Keil5 prepared by the HX711 simulation based on STM32F103T8 driver)