资源列表
lx002
- 基于89C52单片机，驱动16*16led点阵实现0-9循环倒计时的C源代码。-Based on the 89C52 microcontroller, driver 16* 16led lattice 0-9 loop the countdown C source code.
Dynamic-scanning-of-the-digital-tube
- 数码管动态扫描，实现动态显示，单片机51C代码-Digital control of dynamic scanning, dynamic display, microcontroller 51C code
main
- 利用SPI串行接口驱动周立功7289数码管显示按键接口-SPI to 7289
LED
- 单片机LED驱动程序，这里采用了多种方法实现，可以同时学到很多知识，比其他LED驱动资料要全得多-Single-chip LED driver, using a variety of methods to achieve here, you can also learn a lot of knowledge, other than the LED driver is much more to the whole data
led
- LED的点阵程序，包括取字模的方法。单片机开发使用，C52单片机-LED dot matrix program, including taking matrix approach. MCU development use, C52 MCU
source
- 字符串处理以及测试用例检测 字符串处理以及测试用例检测-string process
JDQ
- 继电器控制,设8255为A口输入,C口输出,延时5s,是否有键按下,若有则转exit,查询8255的PA0是否为高电平,若不是则继续,定时时间到，子程序返回
99
- pid控制程序 pid控制程序pid炉温控制程序pid控制程序-pid control pid control pid control pid control pid temperature control procedures
jianpan
- 一种4*4键盘控制程序,键盘已经编码，在数码管上显示键盘序号。-A 4* 4 Keyboard control procedures, the keyboard has been encoded in the digital control number shown on the keyboard.
18B20
- 温度传感器18B20的源程序。利用此程序能，可以了解18B20怎么用。-Temperature sensor 18B20 of the source. Using this procedure can, you can learn how to use 18B20.
leb
- 通过程序控制学习板上的指示灯循环显示，并可以通过按键进行明暗时间长短的调整-Learning through the program control panel lights cycle through and the buttons light and shade through the adjustment of the length of time
CRC
- 使用modbus协议实现循环冗余校验CRC-Modbus protocol with cyclic redundancy check CRC