资源列表
pwm
- 52单片机电机pwm调速功能,c程序可以用l298等芯片控制调速-52 single-chip motor pwm speed control function, c chip program can control the speed with l298, etc.
Text4
- P1口做输入口,接八个拨码开关,以P0口做输出口,接八只发光二极管,(1)编写程序使发光二极管循环点亮。(2)读取开关状态,在二极管上显示出来。 1、根据要求设计接口电路的接线。 2、编写程序使发光二极管循环点亮,时间变化间隔0.5秒 3、编写程序读取开关状态,在二极管上显示出来。 - #include <reg51.h> #define LED P1 //宏定义,使用LED代替P1口(相当于LED=P1) #define ucha
liushuiseng
- 基于51单片机流水灯从上到下流再由下到上流最后闪五次-Based on 51 single-chip light water flows from top to bottom and then from five down to the high end flash
TimerTest
- 一个简单的定时器。定时执行打印信息。每隔5秒钟打印一次。-A simple timer. Regular print information. Every 5 seconds to print.
lesson_8
- 在51单片机中用1602液晶显示屏显示一些数据,如日期名字等-In MCS-51 using 1602 LCD screen to display some data, such as the date of the name
Text1
- PWM控制,运用软件延时,控制占空比大小,可以运用到控制舵机上,也可控制直流电机-PWM control, the use of software delay, control the duty cycle size, can be applied to control the steering, but also can control the DC motor
code
- 设计89C2051来实现定时自动断电重启功能。-reset auto
tlc1549-ADC
- 在keil C51下的 TLC1549-ADC的启动,结果读取程序
1602
- 1602液晶程序 于at89c52 控制-the doc.for 1602.C uesd for 1602.
bujinyuzhiliudiandongji
- 控制四相步进电机旋转。通过4*4键盘控制转速,并且在数码管上显示转速。-Control of rotating four-phase stepper motor. 4* 4 keyboard through the control of speed, and speed of digital tube display.
keyborad05
- 8051单片机上4*4矩阵键盘的扫描方式5-none
Untitled
- 利用Tiger能量法原理,对数据进行能量法处理,提取信号的故障频率-Tiger energy method using the principle of energy method of data processing to extract the fault signal frequency