资源列表
bujindianji
- 驱动步进电机，通过定时器中断控制，通过多次运行通过，很稳定-Stepper motor drive, through the timer interrupt control, running through through many times, very stable
liushuideng01
- 彩灯显示：间隔300ms先奇数亮再偶数亮，循环三次；一个灯上下循环三次；两个分别从两边往中间流动三次；再从中间往两边流动三次；8个全部闪烁3次；关闭发光管，程序停止。-Lantern Show: interval 300ms first odd and then even bright light, cycle three times a light cycle up and down three times two separate flow from both sides to the
sd
- 通过动态扫描方式和定时器，实现数码管和LED显示功能-By dynamic scanning mode and timer, Implementation of digital control and LED display
DS18B20
- ds18b20的头文件 方便实用-convenient and practical ds18b20 header files
pinglv
- 基于单片机的信号频率计算，还提供数码管显示-Signal frequency calculation based on single chip, it also provides digital display
p0-4
- 8051单片机P0口,P1口,P2口,P3口,P4口使用的测试程序-8051 Port P0, P1 port, P2 port, P3 port, P4 port test program used
DAyanglichengxu
- 此程序为51单片机，DA程序设计测试程序-This program is designed to test 51 single DA application procedures
stable-current-sourse
- 实现恒流开关功能，主要应用在LED驱动中，有现今常用的开关电源控制方法-code of C51 stable sourse
magneticdetection-IIC
- 美新公司MMC磁场传感器通过STC89LE系列单片机IIC通信控制检测磁场强度大小-The new company MMC magnetic field sensors STC89LE through IIC communication control test series microcontroller magnetic field size
dy
- HT46R47的A/D电压检测，3位数码显示，TL431作为基准电压-Of HT46R47 the A/D voltage detection
cpu
- 单片机初始化 ,定时器，串口中断参数设置和初始化-chip initial
18b20crc-test-091113
- CRC校验程序，利用MSP430单片机做CRC校验的一个小程序-The CRC program, MSP430 MCU CRC checksum a small program