资源列表
uart
- ARM的P0.0口接LED，串口接Proteus的虚拟终端。每隔一段时间改变一次LED的状态，并且在串口上输出LED的当前状态。-LED contact the port P0.0,and uart port contact the Proteus virture terminal . alter the LED state every a time,and output the curent state to the termial.
ch05-4-5
- 单片机程序 第四章 第5练习题 希望对初学者有帮助-www.pudn.com www.pudn.com www.pudn.com
ad7895
- 基于AD7895的串行模数转换程序，已通过测试，可以正常运行。-Serial based AD7895 ADC program has been tested to work properly.
led
- 用一个按钮开关循环控制四个led灯的闪烁方式，输入时钟10MHz，闪烁频率1Hz-Button switch with a four cycle control lights flashing led the way, the input clock 10MHz, blinking frequency of 1Hz
bmp_pixel
- /*------------------------------------------------------------------------------ 源文件 / 文字 : AVR 宽×高（像素）: 40×24 字模格式/大小 : 单色点阵液晶字模，纵向取模，字节倒序/120字节 数据转换日期 : 2004-8-13 ------------------------------------------------------------------
project4
- 定时计数器,只是基于C51单片机的一小段程序，可以实现机器计时和仿真计时同时进行。-Timing counter, only a small section of single-chip based on the C51 process, can be achieved time and simulation time machine at the same time.
ex4-1
- LED的控制，应用AT89S51芯片的P1口输出跑马灯，使得LED0，1，2，3，4，5，6，7依次闪烁-LED control, application AT89S51 chip output port P1 of the Marquee, the LED0, 1,2,3,4,5,6,7 followed by scintillation
df
- 点阵显示程序 看一下就可以明白点阵的原理 点阵是二极管的集合-Dot-matrix display program look and you' ll understand the principle of dot matrix is a set of diode
bcdk
- 射频开发模块,用于单片机的开发和射频卡的控制程序-RF development module for SCM development control procedures and RF card
1
- 实现数码管的段选位选定义并且还有实现数码管的流水从1-9-Select the segment to achieve digital control Choice of digital realization of the definition and there is running water from the 1-9
adda
- 信号转换，模拟数据采集以及数字信号转换为模拟信号，适用于单片机-the adda analog data acquisition and digital signal converted to analog signals, 8051
STC89C51interrupt
- STC89C51流水灯按键中断程序设计进程-STC89C51 water lights button to interrupt the program design process