资源列表
slac164
- C280x C/C++ Header Files and Peripheral Examples The DSP28xx C/C++ peripheral header files and example projects files facilitate writing C/C++ Code for the TI鈥檚 28xx MCUs. The code can be used as a learning tool or as the basis for a development pl
Lab7-Timer
- 北京瑞泰公司的DSP2407-A开发板的Timer测试程序-Beijing Ruitai' s DSP2407-A development board for Timer test procedures
Lab8-AD
- 北京瑞泰公司DSP2407-A开发板AD试验程序，已经调试通过-Beijing Ruitai company DSP2407-A development board AD testing procedures have been debugging through
Lab10-PWM
- 北京瑞泰公司DSP2407-A开发板PWM试验程序，已经调试通过-Beijing Ruitai company DSP2407-A development board PWM test procedures are debugging through
vportdis
- DSP DM642 视频端口显示驱动程序-the driver program of DSP_DM642
adc
- This example sets up the PLL in x10/2 mode, divides SYSCLKOUT by six to reach a 25Mhz HSPCLK (assuming a 30Mhz XCLKIN). The clock divider in the ADC is not used so that the ADC will see the 25Mhz on the HSPCLK. Interrupts are enabled and the EVA i
ev_pwm
- This program sets up the EV timers (TIMER1, TIMER2, TIMER3 and TIMER4) to generate T1PWM, T2PWM, T3PWM, T4PWM and PWM1-12 waveforms. The user can then observe the waveforms using an scope.
ev_timer_period
- This program sets up EVA Timer 1, EVA Timer 2, EVB Timer 3 and EVB Timer 4 to fire an interrupt on a period overflow. A count is kept each time each interrupt passes through the interrupt service routine. EVA Timer 1 has the shortest period while EVB
flash
- This program sets up EVA Timer 1, EVA Timer 2, EVB Timer 3 and EVB Timer 4 to fire an interrupt on a period overflow. A count is kept each time each interrupt passes through the interrupt service routine.
Example_281xFlash
- This program sets up EVA Timer 1, EVA Timer 2, EVB Timer 3 and EVB Timer 4 to fire an interrupt on a period overflow.
gpio_loopback
- using gpio of 2812 This program requires the DSP281x V1.00 header files. As supplied, this project is configured for "boot to H0" operation.
ex1_RAMTest
- （1）测试外部数据RAM： 根据我们定义的逻辑，外部RAM在数据空间中定义在0x8000－0xFFFF，共32k字，占据RAM中的低32K存储空间。提供2种测试方法，采用一种方式即可。 硬件仿真模式下，将目标板上电。 第一种方法：采用用程序测试实验 程序所在目录ex1_RAMTest。 该程序执行的功能是对外部数据RAM区0x8000－0xFFFF,从0x8000开始写并且读数据0x5555 。如果正常则写读下一个地址，直到 。如果正常则所有的地址操作完毕后，核心板