资源列表
VQ_C_language
- 基于经典LBG算法的矢量量化的C语言实现，注释详尽，很容易让读者理清程序算法和思路。函数的功能和怎么调用，一目了然。-Based on the classic LBG vector quantization algorithm C-language implementation, comment in detail, it is easy for readers to sort out procedural algorithms and ideas. The function and how f
5509A_USB_DPLL_TO_APLL
- The TMS320VC5506/C5507/C5509A USB peripherals can be clocked from either the USB APLL or the USB DPLL. Since the APLL is inherently more noise tolerant and has less long-term jitter than the DPLL, it is recommended that you switch to it for any U
CCS
- 详细介绍CCS在使用中遇到的问题，大家可以-CCS in detail the problems encountered in the use, we can see
cosinexp
- 基于DSP的产生余弦信号的用C编写的程序，可通过CCS平台下载到DSK板上实现信号输出。-DSP-based cosine signals generated C preparation procedures, CCS platform can be downloaded to DSK board signal output.
DAC
- 数模转换程序主要是实现从数字到模拟的转换
DM642_Timer
- Ti DSP DM642的定时器测试程序。包括定时器的设置、启动等。
motor
- 用dsp控制无刷直流电动机的转速，本可以与PC机通信-a program for control
bujindianji
- 很好的DSP代码，关于步进电机的。-Good DSP code, on the stepper motor. Oh Oh
fft
- 基于dsp2812 IQmath下的fft计算，效率很高-Calculated based on the fft dsp2812 IQmath under high efficiency
1211111
- matlab时频分析配套源码第12章的程序，请大家共享-Matlab time-frequency analysis supporting source Chapter 12 procedures, please share
SYBLDCMOTORCONTROLV2
- 无刷直流电机的转速控制，通过三个霍尔传感器实现转速和位置的控制。-BLDC CONTROL
cosinexp123
- 1.分别利用计算法和查表法产生1000Hz的余弦波信号，并使用示波器观测产生信号的频率和幅度。 2.利用计算法产生其他非正弦类周期信号波形，如周期矩形波、三角波、锯齿波等。-1. Each calculation method and the use of look-up table method have 1000Hz the cosine wave signal, Oscilloscope observation and the use of the generated signal f