资源列表
12864
- DSP2812 GPIO应用之蜂鸣器和12864液晶-DSP2812 GPIO application of the buzzer and LCD 12864
shuzixinhao
- 数字信号处理课后习题答案,pdf格式,挺好的。-Digital signal processing after-school exercise answer, pdf format, quite good.
JPEGNetCam2
- 双路网络摄像机,功能完全实现,非常好,注释全面-vidio two well
tests
- TI公司DM6467的test程序,实现各种实用功能-TI' s DM6467 of the test procedure, to achieve a variety of practical functions
bf53x_rtc
- OpenADSP开源社区 ADSP-EDU-BF53x开发板的RTC测试源码-ADSP-EDU-BF53x development board OpenADSP open source community RTC test source
SEED-BLDC-Kitv1.0(Rev.-A)
- 描述了三相无刷直流带电机驱动模板的使用说明,描述了seed-bldc的硬件构成,原理,以及实用方法和编程指导-Using the described three-phase brushless DC motor drive template with a descr iption, descr iption of the seed-bldc hardware structure, principle, and the practical methods and Programming Guide
F2407A_BLDC_sensor
- TI公司的DSP(LF2407A)编写的有霍尔位置传感器的无刷直流电机控制程序,内含子程序说明-TI's DSP (LF2407A) prepared in a Hall of sensorless brushless DC motor control system procedures, containing subroutines note
BLDC_sensor
- 基于dsp 2407的带传感器的无刷直流电机程序。-With sensors based on dsp 2407 in a brushless DC motor program.
47974795svpwm
- SVPWM DSP控制电机的例程,可以看看学习下(SVPWM DSP control motor routines, you can look at the next study)
hex2dat
- 在DSP自起动时,用来将生成的.hex文件转换成.dat文件,只有这样才能正确烧写到flash中-The DSP from the start, is used to generate the hex file convert dat file, the only way to properly programmed into flash
l298-l297
- 介绍了步进电机的驱动电路,并且进行比较适合初学者-Introduced the stepper motor drive circuit, suitable for beginners
4.SPILED
- 通过DSP的串行外设接口SPI来实现数码管1~9的循环显示。-By DSP Serial Peripheral Interface SPI digital control loop to achieve 1 to 9 display.