资源列表
SourceCode5_spi_7Seg_OK
- dsp设计 七段数码管显示实验文件 ccs开发环境 -dsp design documents seven segment digital display test development environment ccs
lab36-SPI
- dsp28335的spi串口通信工程文件，适合初学者学习-Dsp28335 of spi serial communication engineering file, suitable for beginners to learn
lab1-GPIO_LED
- 研旭TMS320F28335开发板GPIO-LED示例程序,如果使用CCS3.3拷贝到安装目录下的MyProject下，不能有中文路径-Yanxu TMS320F28335 research development board GPIO-LED sample program, if CCS3.3 copied to MyProject installation directory, the path can not have Chinese
PWM
- DSP2812 PWM生成配置程序，主要包括死区配置，此代码已经成功调试过-DSP2812 PWM generator configuration program, including the dead zone configuration, this code has been successfully tested over
study_CCS
- Code Complier Studio(CCS)教程-Code Complier Studio (CCS) Tutorial
QXD-DM642video2
- DSP图像采集与显示完整项目文件，很经典的代码，初学者必看-DSP image acquisition and display a complete project file, the code is very classic, must-see for beginners
CC2000
- C200DSP简绍，很不错的一个说明，C200DSP简绍，很不错的一个说明-C200DSP Jane Shao, a very good descr iption, C200DSP Jane Shao, a very good descr iption of
spi——led
- spi通信点亮led，程序详细，可以直接使用
EX21_IIC_EEPROM
- DSP开发板的IIC总线访问EEPROM的程序。测试可以使用。-DSP development board the IIC bus access EEPROM program. The test can be used.
armfly-DSP-tutorials-Chapter-11
- 本教程使用的DSP库来自ARM官方，此库支持以CM0，CM3，CM4以及CM7为内核的所有MCU。本期教程主要讲解统计函数中的最大值，最小值，平均值和功率的计算。-This tutorial uses a DSP library the ARM official, this library supports CM0, CM3, CM4 and CM7 for the kernel of all MCU.
lab50-FFT-FIR
- 基于DSP 28335的傅里叶变化和滤波程序，希望对大家有所帮助-Based on DSP 28335 Fourier change and filtering procedures, hope to be of help
Display
- TMS320X2812 spi显示驱动程序，及显示部分原理图。开发环境为CCS3.1.2812SPI和74hc595通讯，驱动5位LED 数码管。一般做工程都需要有显示部分。这个可以做为公用代码，可以显示小数。已经通过测试。-TMS320X2812 spi display driver, and display portions of the schematic. Development environment for CCS3.1.2812SPI and 74hc595 communicati