资源列表
AIC23
- 声卡芯片AIC23的测试程序，采用TMS320F2812控制，很不错-AIC23 audio chip testing procedures used TMS320F2812 control, very good
2812CANTEST
- TMS320F2812的ECAN通讯测试程序-TMS320F2812 ECAN communications test procedures
DspUsbTem
- 基于dsp2407a的探测系统程序（兼容usb和串口通讯）-dsp2407a based on the detection system (compatible with USB and serial communications)
I2CRCVint
- dsp中关于I2C 的接收数据的操作，通过对eeprom进行读写，达到数据的交流。-dsp on the I2C receive data, the operation of EEPROM write, to achieve the exchange of data.
c6711dsk
- c6711的dsk原理图，相信对很多人有用，PDF文件结构。-the diagram, I believe many people useful, PDF document structure.
dsk_c6713a
- c6713的dsk原理图，相信对很多人有用，PDF文件结构。-the diagram, I believe many people useful, PDF document structure.
dsk_c6416a.
- c6416a dsk原理图，相信对很多人有用。结构非常详细。PDF文件格式。-c6416a DSK schematics, many people believe that the right useful. A very detailed structure. PDF file format.
TMS320C6000BootMethod
- 首先介绍了DSP/BIOS的优点，然后讨论了DSP/BIOS的资源优化方法，最后介绍了使用DSP/BIOS编程时的自举引导方法。-first introduced the DSP / BIOS advantage then discuss the DSP / BIOS resource optimization method, Finally, the use of DSP / BIOS programming at the Boot Method.
concorr
- 计算如序列x[k]={1,2,3,4,5}与序列h[k]={2,-2,3,5}的卷积本程序是和互相关的C源程序。-if the calculation sequence x [k] = () 1,2,3,4,5 and sequence h [k] = (2, ,3, 5) of the deconvolution procedure is inter-related to the C source.
board123
- 1 本程序为DSK板的初始化过程。 2.当DSP的主时钟频率为50MHz时，计算锁定时间定时器PLLCOUNT的值，并修改相关程序。 3.将主时钟的频率分别设置为50MHz、20MHz、10MHz、5MHz，通过观察LED指示灯的闪动频率来验证程序运行是否正确。-a procedure for DSK board initialization process. 2. When DSP master clock frequency of 50MHz, calculation time lo
cosinexp123
- 1.分别利用计算法和查表法产生1000Hz的余弦波信号，并使用示波器观测产生信号的频率和幅度。 2.利用计算法产生其他非正弦类周期信号波形，如周期矩形波、三角波、锯齿波等。-1. Each calculation method and the use of look-up table method have 1000Hz the cosine wave signal, Oscilloscope observation and the use of the generated signal f
TIMER123
- 1.可组合给定内容的程序，利用示波器测量XF或LED0管脚的信号频率。 2.可修改定时器中断服务程序，使三个发光极管每隔1秒钟轮流点亮一次。-1. Portfolio will be content to the procedure, and use oscilloscope measurement XF or LED0 pin signal frequency. 2. Amend timer interrupt service routine, three-top every one li