资源列表
timed_led_blink
- DSP亮灯闪烁，叫你如何使用DSP28035定时器，寄存器。-DSP flashing lights, tell you how to use the DSP28035 timer register.
evmc6678l
- TI 8核DSP TMS320C6678的gel文件 包含个硬件模块的初始化和测试功能-TI 8 cores DSP TMS320C6678 s gel file contains a hardware module initialization and test functions
csl_lcdc_65kColorModeExample
- 基于TMS320VC55xxDSP芯片显示屏例子-example of lcd display based on TMS320VC55xx
2808_hlV1.0
- ti 28xx 8两路PWM波依次相差45°发波配置文件-ti 28xx 8 PWM wave followed by two 45 ° phase difference hair wave profile
armfly-DSP-tutorials-Chapter-12
- 本教程使用的DSP库来自ARM官方，此库支持以CM0，CM3，CM4以及CM7为内核的所有MCU。本期教程主要讲解统计函数中的标准偏差、均方根和方差的计算。-This tutorial uses a DSP library the ARM official, this library supports CM0, CM3, CM4 and CM7 for the kernel of all MCU.
RTC
- 通过dsp调试助手将信息发送给dsp，dsp接收信息会对x1226 进行写操作，从而完成对rtc的校验-By dsp debugging assistant to send information to dsp, dsp receive information will x1226 write operation, thus completing the rtc check
CAN_TX
- 本例使用can调试器发送数据给dspcan接口，dsp can接口接收数据-This example uses the debugger can send data to dspcan interfaces, dsp can interface to receive data
GpioLed
- 使用gpio引脚外接两个并联5欧姆电阻，一路电阻串接发光二极管 ，实现对发光二极管的控制-Gpio pin external use two parallel 5 ohm resistor in series resistance all the way to the light-emitting diodes, light-emitting diodes to achieve control
Spi01
- 使用74hc595与dsp的spi进行通信，点亮led数码管使得数码管从0-f循环显示-Use 74hc595 and dsp of spi communication, lighting led digital tube makes digital cycle 0-f
example2_LED_KEY
- DSP中，发光二极 管轮流点亮，从下至上(或从右至左)分别点亮,当按键按下时流水灯立即改变方向闪烁，再按 下按键后流水灯又立即改变方向闪烁。-DSP, the light emitting diode ROTATE, bottom to top (or right to left) are lit, when the button is pressed to change the direction of the water lights flashing immediately, then
armfly-DSP-tutorials-Chapter-11
- 本教程使用的DSP库来自ARM官方，此库支持以CM0，CM3，CM4以及CM7为内核的所有MCU。本期教程主要讲解统计函数中的最大值，最小值，平均值和功率的计算。-This tutorial uses a DSP library the ARM official, this library supports CM0, CM3, CM4 and CM7 for the kernel of all MCU.
6678_SRIO
- TI的8核6678的SRIO测试程序，亲测可用-TI 6678 test code for srio,it is useful for new users