资源列表
5.3－GPIO实验
- ARm实验板magicArm下面的实验内容，为GPIO实验源代码-ARm magicArm experimental plate below the experiment, for the GPIO experimental source code
5.6－PWM实验
- MagicArm开发环境下的PWM实验源代码，采用c语言编制-MagicArm development environment under the experimental PWM source code, using language c
miniweb-0.7.5
- MINIWEB 0.75, 可以用于嵌入式系统设计。-MINIWEB 0.75, can be used in embedded system design.
CAN协议控制器的Verilog实现
- 基于FPGA的CAN总线控制器，VERILOGHDL源代码，Q2仿真实现。可用。-FPGA-based CAN Bus Controller, VERILOGHDL source code, Q2 Simulation. Available.
yamon-sampleappl-src-02.03
- Support is available from MIPS Technologies Inc. - problems should be addressed to support@mips.com。This product may be controlled for export purposes. You may not export, or transfer for the purpose of reexport, any technical data received
high_api
- VC0558 BackEnd IC Program
St7920pP
- st7920是现在比较好用的一款液晶显示控制器，内部含有GB5中文字库，以及图形点阵。本文是ST7920的应用实例，并通过检验，共大家参考。-st7920 is now more user-friendly new LCD controller, GB5 contain internal Chinese font, and graphics dot-matrix. This is the Driver of application examples, and through inspection
ds1620
- 这是数字式温度测控芯片DS1620的C51驱动程序，包括芯片初始化，温度读取，温控阀值设置等-This is the digital temperature control chip DS1620 C51-driven procedures, including chip initialization, Temperature read, such as valve Sets
华恒
- 华恒嵌入式的培训的资料，里面有包括很多的pdf文档，而且非常详细，大家可以参考一下。-huaheng embedded training, and there are many, including the pdf documents, but very detailed, we can take a look.
firmware12.6
- 提供了usb接口fx2芯片的编程。从io输入到后来的差分信号输出。都给了详细的例子-provided accordance usb interface chip programming. Io from input to the subsequent differential signal output. Gave a detailed example
modbus2002-1d
- 自已编写的MODBUS程序，主要用开工业上PLC、现厂仪表、控制系统之间的通讯。-own MODBUS prepared by the procedures, which was spent mainly on the open industrial PLC, the plant instrumentation, control system communications.
GE15
- 同步发电机同步电动机软启动电子开关通用的晶砸管控制程序.-synchronous generator synchronous motor soft-start electronic switch generic crystal smashing control procedures.