资源列表
PmacCtrl_v5.1
- 利用VC编写的PMAC控制芯片驱动程序，用以通过PMAC芯片驱动五轴联动机床。-VC prepared by the PMAC control chip driver, PMAC chip to drive through 5-axis machine tools.
COMAssist1.51
- 参考萧峰工作室的串口例程,使用mscomm 6.0编写,创新之处在于程序启动时自动检测并安装ocx控件,自动检测串口,单个文件方便使用,不需要手动安装ocx控件,另外也有许多细小功能的增加,如16进制自动过滤,设置参数的自动保存,相当稳定和人性化,界面布局参考了\"串口调试器 2002\",谢谢上面的两位大侠. 使用VC++ 2005编译,winxp home/pro测试,本人开发中长期使用. -reference to the serial routines, the use o
armok018882
- 12864lcd的程序，经过测试过的，大家放心参考使用吧。呵呵资源共享啊-12864lcd procedures are followed, tested, and they assured reference it. Ah-huh resource sharing
rgb-1
- 汉字显示屏 汉字显示屏-Chinese character display Chinese characters display Chinese characters display
msp430pwmgenerator
- 本程序可以实现在msp430上产生pwm输出信号，主要用于电机的pwm控制-this procedure can be achieved in the Controller produce pwm output signal, mainly for the pwm motor control
canpie_src_v1r92
- canpie 一个can bus的协议栈 - CAN interface for embedded control - CAN interface for PC (without local processor) - CAN interface for PC (with local processor) -canpie a bus can the protocol stack-CAN interface for em bedded control-CAN int
avr_mcp_20050419
- CAN-CAN - Controller Area Network Projects-CAN-CAN-Controller Area Network Projects
uclinuxtcpudpserver
- uclinux下tcp和udp服务器的建立-Basis under tcp and udp server building
MCP2510CAN
- ARM7 MCP2510的CAN程序-ARM7 MCP2510 CAN procedures
My44B03.9_44b0
- ucgui3.90在44b0上的移植，自己移植的，还请斑竹给批准啊，谢谢。-ucgui3.90 44b0 in the transplant, the transplant itself was also requested to approve Banzhupai ah, thank you.
229014nandflash_hal
- 51平台下直接使用IO引脚读写NANDFLASH C模块,包括Write_cmd,Write_add,Write_data,Read_Data等-51 platforms direct use IO pins literacy NANDFLASH C module, including Write_cmd, Write_add, Write_data. Read_Data etc.
aa_2
- 使用定时器Timer5，设定44B0定时器Timer5工作在中断方式,在Micetek板的led上依次循环显示10进制数9，8，……,0,每隔1秒,更新显示一个数字-Timer5 use timer set 44B0 Timer5 timer interruption in work, Micetek plate in the cycle were led on the 10-band show a few 9, 8, ..., 0, every one seconds, updated fig