资源列表
RFID
- 基于cc2530的RFID射频卡程序,已经调试好的-The RFID-based cc2530 RF card program has been debugged
adc_voltage
- 基于cc2530单片机的用片内的adc做电压表的源码-Do voltmeter adc cc2530 source-based microcontroller with on-chip
Watch-Dog
- zigbee芯片cc2530的看门狗,采用IAR平台调试 。-cc2530 watchdog, using the IAR debugging platform.
code
- 输入密码正确,锁开(绿色指示灯亮),密码不正确,锁保持关闭状态(红色指示灯亮),并且蜂鸣器报警。密码输入错误可进行删除。显示器为两个四位一体数码管。-Enter the correct password, the lock open (green light), the password is incorrect, the lock remains closed (red light), and buzzer alarm. Password input error can be deleted.
oled
- 矩阵键盘,部分按键 控制OLED oled上会显示相关数据,有模式切换和数据加减的功能。-Matrix keyboard, some keys control LCD will display relevant data on oled, there is subtraction mode switching and data functions.
USART-TO-MNUSART
- MCU avr ATmega168 实现485串口与模拟串口间数据透传 ICCAVR源码。自己写的-MCU avr ATmega168 实现485串口与模拟串口间数据透传 ICCAVR源码。自己写的
matrix-keyboard
- 利用扫描式键盘算法实现通过按4*4矩阵键盘控制数码管显示0—F-Use keyboard scanning algorithm by pressing the 4* 4 matrix keyboard control digital display 0-F
xndn
- 各种步进电机,直流电机在C语言的环境下的控制程序。-A variety of stepper motors, DC motors in the C language environment control program.
ZK-Step_20140116165926
- 各种步进电机,直流电机的C语言环境下的控制程序-A variety of stepper motors, DC motors in the C language environment control program.
jydjbj
- C51程序,把控制器程序已经用在产品上。包括定时器的使用,步进电机的控制技巧-C51 program, the controller program has been used in the product. Including control techniques timer, stepper motor
bjmd
- 包含单双八拍,双四拍的步进电机的加减速控制。 -Mono contains eight beats, acceleration and deceleration control dual four-beat stepping motor.
gd
- 包含四线步进电机的正反转控制程序以及原理图和电路图。-It contains four-wire stepper motor reversing control procedures as well as schematics and circuit diagrams.