资源列表
main
- 矩阵键盘实验。数码管使用P0,键盘使用P3.0、P3.1、P3.2、P3.3。按矩阵键盘分别显示在数码管上面显示十六进制的0到F。-Matrix keyboard experiments. Digital control using P0, keyboard P3.0, P3.1, P3.2, P3.3. Matrix keyboard are displayed in hexadecimal 0 to F. In the above digital
9720LCD
- 使用51控制9720液晶显示屏12864包含指定位置写入数据-LCD display with 51 control 9720 writes the specified location contains 12864
HD7279A
- 使用HD7279芯片,实现循环右移、闪烁等功能-Using the HD7279 chip, rotate right, flashing etc.
i2c软件包
- 以模块化的形式给出i2c总线模拟编程软件,不管什么芯片,只要是i2c总线,不加改动或改动很少就可使用-in a modular form is i2c Bus simulation software programming, no matter what the chip, as long as it is i2c bus, without change or modification can be used rarely
ulstrasonic
- 应用在51单片机上的超声波测距,通过串口显示,HC-SR04超声波测距模块-Ultrasonic ranging applications in the 51 SCM display through the serial port, HC-SR04 Ultrasonic Ranging module
GSM
- This source help arduino to connect with a gsm shiled
shotmessage-call
- 利用三个按键实现短信“警告:有人进入监视范围!”“警告:煤气泄漏!”和向15153560662打电话-Achieved using three key messages " Warning: Some people enter the monitoring of range!" " Warning: a gas leak!" And to call 15153560662
pin-defination
- 使用tcl文件分配管脚 比如在quartus里面建立一个setup.tcl的tcl文件,器件为EP1C6Q240 第3,4行表示所有不用的管脚默认为输入三态 第6,7行分别把芯片的28和2脚分配给了设计中的clk和key1 -Use of tcl quartus such as file allocation pins inside a setup.tcl the tcl file, the device is EP1C6Q240 3,4 line that all un
servo
- Manejo de un servo por rs232 con compilador C de CCS
follow_line
- 实现智能机器人巡线控制方案,机器人的前轮,后轮行走都在其中,非常值得参考,其巡线精度很准确的,是我自己亲自做过的-Intelligent robot patrol line of control program, the robot' s front wheels, rear walk in them, very good reference, its Patrol line accuracy is very accurate, I have personally done
lcd12864
- 显示程序 点阵128×64的点阵显示屏 驱动程序-128 × 64 dot matrix display program of the dot matrix display drivers
key
- 双按键控制数码管加减一,双按键控制数码管加减一-Two-button control of digital tube plus or minus one or two-button control of plus or minus a digital tube