资源列表
SweepGenerator
- This is a working Sweep-Generator CCS C Programm. It runs on pic24 and dsPIC33. It controls the AD9850 DDS board connected in serial mode via pin data_7. There are 3 buttons that control the program state. Two led diodes on pin_b2 and pin_b3 indicate
main
- 接口技术键盘阵列实验，通过proteus模拟，按下一个键，led灯会闪烁该键号的次数。-the key
msp430x41x2_uscia0_uart_06_9600
- MSP430F41X2 UART 异步通讯例程-MSP430F41X2 UART asynchronous communication routines
DHT11Source
- DHT11温湿度传感器在cc2530中的驱动-DHT11 for cc2530 in z-stack
atmega16.rar
- atmega16 定时器1 两路 pwm交替输出 方法 可用来驱动半桥,atmega16 Timer a two-way alternating pwm output method can be used to drive the half-bridge
autobaud
- set auto baud program
New
- this program communicates between RTD results and matlab.
target
- 2lpc2000系列的target.h文件 2lpc2000系列的target.h文件-2lpc2000 series target.h document 2lpc2000 series target.h document
S7-200-motor
- 用S7-200来控制电机正反转，非常好，简单实用，且方便。-S7-200 to control the motor reversing, very good, simple, practical, and easy.
jixieshou
- 控制机械手工作！ 控制机械手抓小球从A到B的工作状态-Controls the robot work! Control a mechanical grasping the ball from A to B the operating state
nxUART
- class to work with UART port on ATmega128/ATmega2560
LCD1602
- 基于单片机的LCD1602的定时程序，晶振12MHZ-To have the timing based on SCM procedures LCD1602