资源列表
SAR image using LFM signal
- simulation of Synthetic Aperture radar where the transmitted signal is linear frequency modulated waveform
DANPIANJIJIEKOUDIANLUSHEJI
- 设单片机内部RAM中有两个长度为20的数据块，其起始地址为分别为addr1和addr2，编写把addr1和addr2中数据同步输出的程序-Let MCU internal RAM has two length data block 20, which is the starting address for the addr1 and addr2, addr1 and write the data synchronization output respectively addr2 program
fet140_i2c_15
- i2c control for temp sensor tmp1-i2c control for temp sensor tmp100
c8051f005-SPI-SCA100T
- 使用c8051f005通过SPI读取SCA100T角度值的程序-Use c8051f005 read through the SPI program SCA100T angle value
SDDriver
- SD驱动驱动
ADCSpeedManager
- ADCSpeedManager程序 系统已经通过PIC单片机测试通过，系统用与汽车发动机冷却系统直流电机控制。-ADC Speed Manager and cinvert for BLDCM control used pic single mcu .It is tested by pic mcu in car motor drived.
button
- button.cpp for stm32f429
8563pro.C
- 89c51实现读PCF8563的可移植的程序，在实验班调试通过。-Reading achievement of the 89c51 Portable PCF8563 procedures adopted in the experimental class debugging.
C51PCH452
- 此资料是用于c51温控系统的分块部分测试，对于数码管显示，采用的是动态扫描，用到CH452，有三个程序，CH452控制数码管显示，温度显示，以及键盘输入用数码管显示验证是否正确。注：该资料格式是.TXT ，需要在运行环境下自行转换文件格式-This information is used to block some of the test c51 temperature control system for digital display, using dynamic scanning, use
wgj12345
- 这是一个用程序使单片机产生pwm波去控制电机转动的程序,可以参看的
STM32SPI1-SPI2-SPI3
- STM32中SPI1/SPI2/SPI3的设置程序-the SP1/SP2/SP3 config program for STM32
TESTE3-1
- sequence for phase control with Ir command at 8051 plattform