资源列表
LED1
- ATMEGA16芯片 LCD1602，红外发射遥控器 型号TC9012或者万能遥控器， 驱动开发板上的LED-The ATMEGA16 chip LCD1602, remote control models of the infrared emission TC9012, or universal remote control panel LED driver development
读卡器程序
- 这是一个读卡程序，利与开发
RFIDreaderprogram
- RFID读卡程序。硬件工作原理：基站在上电的情况下通过耦合线圈发射频率为125k的正弦波，ID卡的耦合线圈在125k的正弦波的激励下产生感应电动势，它为整个ID卡提供电源。ID卡通过调制电路根据其卡类的数据使ID卡的耦合线圈也发出正弦波，基站的耦合线圈接收到，根据它与125k波的不同来表示不同的数据。并将其通过DATA端以曼切斯特码的形式输出。-RFID reader program. Hardware it works: At the base station on the case of e
main
- PIC 16F876 based motor controller to control dual motor with forward mode and reverse mode and regenerative braking.
RssiM
- 实现RSSI信号的16个Node节点采集程序，请注意对应的文件名，烧制时注意节点ID号。以下是完整的Node节点程序。-RSSI signal to achieve the 16 Node node collection procedures, please note the corresponding file name, firing the attention node ID. The following is the complete Node node procedure.
Example_2823xAdcToDMA
- this C program is used to program TMS320F2823 internal ADC.
STM32-EXTI
- 当使用外部中断时，出现#20 identifier EXTI15_10_IRQChannel is undefinedSTM ，因为官方库升级的原因，该源程序帮你解决你的问题-When using an external interrupt, appear# 20 identifier EXTI15_10_IRQChannel is undefinedSTM, as reasons for the upgrade of the official repository of the source
MCU
- AT89C51与P89C52点对点单片机之间通信的发送和解手程序-AT89C51 single-chip and point-to-point communication between P89C52 sending hand of reconciliation procedures
SD
- SD卡读写功能，实现了根据ds1302的时间写数据-The SD card reader function, realizes the DS1302 according to the time to write data
startup
- arm lpc21xx启动代码,代码翻译.-arm start
piccds1302
- pic的时钟芯片程序，ds1302，c语言版的-pic of the clock chip procedures, ds1302, c language version of the
Temperature_Alarm
- 基于51单片机和C语言的温度报警器的设计，可手动设置温度- U57FA u5351 u5355 u7247 u7A8 u7B3 u7B0