资源列表
bujindianjiyuanli
- 利用按键控制步进电机正转，反转，加速，减速。驱动方式采用一相励磁。-Controlled stepper motor with the key forward, reverse, speed up, slow down. The drive mode using the one-phase excitation.
1alljia
- 只要或上有事件发生，门实例语句即被执行。只要或上有事件发生，就执行语句，并且只要或上有事件发生，就执行连续赋值语句。
pwm
- 89C51单片机用定时器来产生ＰＷＭ方波，方波的频率与占空比可调
main
- TI公司的ZigBee模块 cc2530单片机带屏基础实验---LCD-test-TI ZigBee module CC2530 chip with screen based experiment--- LCD-test
interruput
- 利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz。 使用的是T0口在1方式下工作的-Use timing counter T0 from P1.0 output/1s of square wave period, let light emitting diode to 1HZ flashing, set crystal frequency for 12MHz. Use is T0 mouth in 1 mode
testeLCD
- código para dysplay LCD 4Bits no ATMEGA328
ex1
- PC104总线，使接在PB口上的4个绿灯亮，4个红灯灭-PC104 bus, so connected to the PB port 4 green light, red light off 4
LED
- 用ATMEGA16芯片单片机实现 步进电机缓慢单向转动 -ATMEGA16 chip microcontroller stepper motor slow unidirectional rotation
pid-control-program
- pid示例程序，使用arduino单片机-pid example, the use arduino microcontroller
LCD-display-16x2-8bit
- LCD 16x2 8-bit code for atmel uc3c0512c microcontroller
Bluetooth_Pass_Lock
- Arduino bluetooth code to change bluetooth module pin
da-dac714
- 基于MSP430的DAC714 电压转换程序-MSP430 based on the DAC714 conversion process