资源列表
chuankoushoufa
- 串口收发程序。。 。 stm32f103zet6- Serial transceivers procedures
基于单片机的秒表
- 暂停开始继续复位正计时倒计时可以 设置时间
CC2530_SPI_ADS1255
- CC2530驱动24bit高精度模数转换器ads1255，将结果通过串口打印出来-24bit high-precision analog-digital converter ads1255 was drivered by CC2530, and print out the results through the serial port
stc12c2052ad
- STC12C2052AD 通过自带的AD采集模拟电压 并通过级联的两74hc595 驱动四位数码管 显示所测电压-STC12C2052AD through own AD sampling analog voltage and through the cascade of two 74 hc595 are needed to drive the four digital tube display the measured voltage
DS18B20
- C8051系列单片机 与ds18b20通讯 ，并将温度值用1602液晶显示-C8051 series single chip microcomputer through external AD convert analog signal acquisition four road And with 1602 liquid crystal display (LCD) Through the buttons in screen Respectively according to four the i
C51-AD
- C8051系列单片机 通过外部AD转换 采集四路模拟信号 并且用1602液晶显示 通过按键换屏 分别显示四路的信息-C8051 series single chip microcomputer through external AD convert analog signal acquisition four road And with 1602 liquid crystal display (LCD) Through the buttons in screen Respectively acc
mima
- 用S3CEV40试验箱上小键盘和超级终端，设计一个简易密码键盘，键盘布局如图所示， 要求： 1. 输入密码时，只显示“*”， 2. 密码位数为6位，超过六位后，不再显示，但输入有效 3. 按下“确认”键后（该键位不显示），与预留密码进行比较 4. 比较正确，显示“OK！”，否则显示“Error！” 5. 连续三次错误后，锁定键盘 -S3CEV40 chamber with the keypad and super terminal, designed a simple
C8051F060-DAC
- 这个程序输出正弦和余弦波形 使用DAC硬这C8051F060单片机DAC0波形输出 和DAC1 Timer4中断更新的输出DAC.Timer4 ISR的 然后导致了DACs计算的输出,这是下一个中断。 输出波形的频率设定的# define <频率>。 实现定义的精确输出频率<频率>,一个 /使用外部晶体。-This program outputs sine and cosine waveforms using the hardware DACs // on t
C8051F060-AD-UART1
- C8051F060 自带高速AD进行数据采集 可达100兆采样率 并切缓存与片外ram 并把采集数据通过串口发送给PC - Data Acquisition example for C8051F060 Descr iption: This example illustrates the use of ADC1 and the DMA to acquire and store data. It is intended for use with the C8051F060
DuankouEMCCircut
- 常用的端口电磁兼容设计电路，对电磁兼容和安规方面的产品设计有很大帮助。-EMC common port circuit design, electromagnetic compatibility and safety aspects of the product design helps a lot.
FTM_1.0
- 直流电机驱动及模块化程序 19264屏驱动及相关程序
2
- ADC0808将电压值转化为数据量通过译码器显示-ADC0808 the voltage value converted to the amount of data displayed by the decoder