资源列表
Bcode-terminal
- B码终端，可以解调输入B码，也可以编码输出B码-Code of the terminal B, B may demodulate the input code, the code may be encoded output B
GPS-Data-display
- GPS数据分路显示终端，通过液晶屏显示经纬度-Shunt GPS data display terminal, the LCD screen displays the latitude and longitude by
WATERING
- 毕设时候用的自动浇水系统的仿真程序,是基于单片机的-Simulation program complete set of automatic watering systems
SCH_51_A
- 单片机测电阻电容原理图 硬件原理图 555振荡原理 通过测频换算对应的电阻电容值-Single Chip Microcomputer measured resistance and capacitance schematic hardware schematic diagram 555 oscillation principle by frequency conversion corresponding to the resistance and capacitance value
SCH_51_B
- 51单片机控制自动窗帘模拟电路，有时钟、存储器、驱动等，仅有硬件设计！-51 single-chip control automatic curtains analog circuits, clock, memory, drive, etc., only hardware design!
SCH_51_C
- 单片机控制ESP8266硬件设计，包含液晶等的链接方式，单片机采用STC15系列！-SCM control ESP8266 hardware design, including LCD and other links, single-chip STC15 series!
SCH_51_D
- 51单片机设计的数控电压源原理图，包含电源设计，DA部分、运放输出部分！-51 single-chip design of the numerical control voltage source schematic diagram, including power supply design, DA part, op amp output part!
SCH_51_E
- 采用32位单片机控制BOost电路升压，此电路为主控回路，非常有用！-32-bit single-chip control BOost circuit boost, the circuit for the main control loop, very useful!
Gesture-remote-control-car-package
- 基于单片机代码，我们能通过手势调控小车启动或停止。-Based on the microcontroller code, we can start or stop by gesture control trolley.
digital-clock-circuit-.ms13
- 数电_Multisim设计_数字时钟电路 (显示时:分:秒 CP 频率 f 1Hz) 【电路说明】 1 基于 74LS160 做三个计数器(时:24 进制,分:60 进制,秒:60 进制) 2 秒针计数器完成一次计数后,进位给分针计数器的 P 和 T。 分针计数器完成一次计数后,进位给时针计数器的 P 和 T。-Digital circuit _Multisim design _ digital clock circuit (Display: hours: minutes
EP94Z1E-Schematics
- This the schematic of the EP94Z1E DEMO V1.O BOARD. This IC is usually used in HDMI to VGA converters.EP94Z1E is a Low Power HDMI/MHL Receiver with VGA/Audio outputs and embedded MCU. The chip accepts HDMI/MHL dual-mode input and convert the input sig
ug176
- ug-series servovalve