资源列表
SHT30
- SHT30驱动,直接调用初始化函数，读取温湿度函数即可获取温湿度信息，只需按照自己硬件修改底层硬件接口代码-SHT30 driver
BodePlots
- 利用MATLAB实现一种单相逆变器的控制系统波特图分析- U5229 u758MATCC u5B9E u73B0 u4E00 u79CD u5355 u76F8 u9006 u53D8 u5668 u7684 u63A7 u5236 u7CFB u7EDF u6CE2 u7279 u56FE u5206 u6790
A2
- 对单相逆变电路的MATLAB的仿真，可以观察到方波的波形。-The simulation of MATLAB for single-phase inverter circuit can observe the waveform of square wave.
1
- Creating, Compiling and Running C++ Programs from the Command Window For Introduction to C++ Programming
3
- Data transmission between AVR and peripheral devices like sensors is straightforward – Connect the device to one of the AVR ports and read the port • Data transmission between two AVRs or an AVR and a PC is more complex – Requires a
4
- #define F_CPU 16000000 // run CPU at 16 MHz #define LED 5 // Boarduino LED on PB5 #define ClearBit(x,y) x &= ~_BV(y) // equivalent to cbi(x,y) #define SetBit(x,y) x |= _BV(y) // equivalent to sbi(x,y)
5
- Check the clock frequency & that the baud rate required can be achieved. Error of <1 is never a problem, <2 will work but is undesirable, 5 will not work. Note that this assumes that the other end of the link has perfect timing, which will norm
nibian_PCB
- 逆变主板设计图纸，采用基于IR2110芯片的驱动模块-Inverter motherboard design drawings, based on IR2110 chip driver module
round_light
- 基于atlium designer的圆形灯设计，包含原理图及PCB板设计图纸-Based on atlium designer round lamp design, including schematic and PCB board design drawings
2011
- 蓝桥杯2011决赛答案，你麻痹 草泥马 -hello 哈哈哈
power-m-DIY
- 关于功率放大器的电子书籍，手把手教你使用功放，很好的教程-On the power amplifier of electronic books, hands to teach you to use the amplifier, a good tutorial
Xmc1302-minimum-system-board
- XMC1302最小系统板,可以作为开发英飞凌XMC1302单片机的硬件参考-Xmc1302 minimum system board, can be used as a hardware reference for developing Infineon xmc1302 microcontroller