资源列表
uArmCreatorStudio-master
- 上位机软件 也是开源的 ，带3D直接视图功能，直观显示轨迹 与图形化变成(The host computer software is also open source, with 3D direct view function, intuitive display of trajectory and graphics into)
SwiftProForArduino-develop
- 这个是UArm的开源控制软件 以及固件 对于参考机器臂开发很有帮助。定位精度已经达到0.2mm 而且 还有手势教学功能(This is UArm's open source control software and firmware, which is very useful for reference robotic arm development. Positioning accuracy has reached 0.2mm, and gesture teaching function)
pm2.5
- 一个基于攀藤G7传感器的PM2.5检测仪(A G7 sensor based on akebi PM2.5 tester)
STM32F10x_StdPeriph_Lib_V3.5.0
- stm32f103固件Lib STM32F10x_StdPeriph_Lib_V3.5.0(firmware Liberary of stm32f103 STM32F10x_StdPeriph_Lib_V3.5.0)
client
- 由STM32读取相机数据,从中渲染出图像,并将其另存为jpeg文件(Read data from STM32 though UART, and render image with the data received. The image rendered will be then saved as a jpeg file)
car_battery_charger
- car battery charger for charging battery after drained to 20% start engine
STM32_BLDC
- stm32的无刷电机驱动实现代码，foc矢量控制(STM32 brushless motor driver code)
RFIDRC522
- arduino RFID RC522读写程序(arduino RFID RC522 read)
baseflight-master
- baseflight飞控 stm32f103 KEIL程序，可用于二次开发.(Baseflight flight control STM32F103 KEIL program, can be used for the two development)
Arduino_20150411
- ArduCAT是Arduino Compatible 开发板。本产品力图通过Arduino技术，大大简化EtherCAT从站的开发。ArduCAT开发板包含两路可用于EtherCAT实时以太网的100BASE-TX网口，所以它特别适合基于PC的自动化方案。ArduCAT使用ATMega1280 处理器，兼容Arduino Mega开发板，并具有完全相同的引脚定义。板上采用开关稳压器提供5V 或3.3V的2A直流输出，且发热甚微。除配套的开源Arduino库外，还配有从站应用层代码自动生成工具，
TI单相逆变器
- ti官方单相并网逆变器PCB，原理图，程序，核心板原理图暂时还没开源，核心板用的是TI的F28379D controlCARD for C2000 Real time control development kits，淘宝有的卖， PCB 和 原理图是altium的 Hardware Features Baseboard with interface to accept HSEC180 controlCARDs 380V DC input, 110Vrms 60Hz or 220Vr
marlinsourcecode马琳固件精读
- 台湾人关于marlin固件的精彩简略解说(an brief but excellent introduction of marlin hardware)