资源列表
autofocus
- 显微镜自动对焦MFC+opencv，包括数据采集和聚焦评价函数算法，后面继续奉上步进电机控制-Microscope autofocus MFC+opencv, including data collection and focusing evaluation function algorithm, the latter continue to offer the stepper motor control
jiaozheng
- 这是一个阵列校正的程序，通过计算协方差矩阵，利用矩阵元素间的关系计算出阵列的幅相误差-This is an array of calibration procedures, by calculating the covariance matrix, the relationship between the matrix elements of the array to calculate the amplitude and phase errors
CAD
- 南京航空航天大学的CAD制图教程，很适用，对新手来说它有许多方面的优点，使新手很容易掌握CAD制图的fangfa-Nanjing University of Aeronautics and Astronautics of the CAD drawing tutorial, it is applicable, on the green hand for it has lot of advantages, so that novices can easily master the CAD drawi
VSCTrans
- PSCAD 电压型高压直流输电 高压直流输电-PSCAD VSC-HVDC
Motor-frequency-characteristics
- 在pscad中，双馈，同步，异步，电机频率特性的对比-Synchronous，Asynchronous，dfig ,Motor frequency characteristics of contrast in pscad
applyhatch_pluscolor_bundle
- matlab绘图中柱状图增加图案，用于区分不同柱状图-matlab drawing increased histogram pattern is used to distinguish between different histogram
StockGraph
- python 做的显示股票K线图的源代码。 从通达信软件中读取数据，显示出制定代码的K线 使用Python 2.6 和 wxPython 2.8.1 -do python stock K line graph displays the source code. Mastery letter reads data from the software, showing the development of the K line of code Use Python 2.6 and
MATLAB
- 绘制二维平面内的voronoi图，并给出多边形顶点坐标及面积-plot voronoi
OAM
- 用于产生轨道角动量OAM的示意图和场强图-this code can generate the plot of orbital angular momentum
1
- 2．利用FFT对信号进行谱分析 对于连续信号xa(t)=cos(2πf1t) +5cos(2πf2t) +cos(2πf3t) ，其中f1=6.5kHz, f2=7kHz, f3=9kHz, 以采样频率fs=32 kHz对其进行采样， （1）对xa(t) 信号采集16点样本，分别作16点和补零到256点的FFT，并分别绘出对应的幅频特性曲线。 （2）对xa(t)信号采集256点样本，分别作256点和512点的FFT，并分别绘出对应的幅频特性曲线。 （3）比较（1）和（2）
STC12-ST7567-LCD12832
- JLX12832G驱动程序，单片机用STC12C5A60S2，液晶控制器ST7567，液晶点阵12832，带中文字库-jlx12832 LCD C51 driver, with stc12c5a60s2 microcontroller, lcd controller is st7567, with chinese fonts build in.
点线矛盾检查
- 检查等高线点线矛盾工具，检查等高线节点与高程点是否矛盾(Check contour line point contradiction tool)