资源列表
simulink
- 针对传统PID控制器参数整定不易的局限性，将模糊控制与PID相结合，构造了一个模糊自整定PID控制器,-Traditional PID controller parameter tuning is not easy the limitations of the fuzzy control and PID combination structure of a fuzzy self-tuning PID controller
zhiliudianjiMATLAB
- 直流电机MATLAB仿真程序，希望大家喜欢-DC MATLAB simulation program, hope you like. . .
zr
- 1. 用双线性变换法设计一个巴特沃斯低通IIR数字滤波器。设计指标参数为：在通带内频率低于0.2π时，最大衰减小于1dB；在阻带内[0.3π, π]频率区间上，最小衰减大于15dB. 2.0.02π为采样间隔，打印出数字滤波器在频率区间[0, π/2]上的频率响应特性曲线。 3. 用所设计的滤波器对实际心电图信号采样序列进行仿真滤波处理，观察总结滤波作用与效果 附：心电图采样序列x(n) 人体心电图信号在测量过程中往往受到工业高频干扰，所以必须经过低通滤波处理后，才能作为判断心脏
stbc21
- stbc在锐利信道的2发2收情况下的信噪比与误码率-stbc sharp channel 2 in the hair under 2 receive signal to noise ratio and bit error rate
veryusefulfacerecognition
- 这里面有三个：k-L人脸识别的代码（可以直接用，qq：285494355），以及2D-LDA人脸识别，以及一个图像分割的程序。-K-L and 2D-LDA face recognition ,it s useful and can be used directly.
TDNN1
- Speech Recognition with TDNN(Time delay neural network)
blindsignal
- 研究盲信号的盲分离原仿真程序，其中有一个是应用ICA的-Of blind signal separation from the original simulation program, one of which is the application of ICA,
xingguanfx
- 运用相关分析法来进行系统辨识，采用的是M序列输入信号。-Carried out using correlation analysis, system identification, using the M sequence input signal.
Genetic-algorithm
- 有约束的最优问题，对优化求解很有用，特别是在运筹规划问题上用途很大-The constrained optimization problem, on the optimal solution is useful, especially in the use of large logistics planning issues
PID_jieou
- PID解耦，用于多变量解耦，是个很好的例子，希望对大家有用-PID decoupling, for multi-variable decoupling is a good example, in the hope it would be useful
LMS_correlative
- 此程序是用MATLAB编写的时域解相关的LMS自适应算法程序。-This program is written in MATLAB for time domain LMS adaptive algorithm related procedures.
Chase
- 自己写的一个关于chase算的程序，能得到最后的译码结果。主要用于乘积码和广义LDPC的译码算法上，有较好的性能。-Write a program to calculate on the chase, will be the final decoding results. Mainly used for product codes and generalized LDPC decoding algorithm, there is better performance.