资源列表
nihecizhihuixian
- 测量的磁滞回线数据使用matlab拟合的方法-The measured hysteresis loop data is matlab-fitted
OFDM-Transceiver
- The numbers used are those IEEE 802.11 (WiFi). The transceiver can run in stand-alone mode as a simulation by using the channel model. The transmitter and receiver can also be paired with a USRP Source and Sink nodes for over-the-air experimentation
bee
- 将人工蜂群算法应用到机器人路径规划问题上，使机器人路径规划问题得到很好地解决。-The artificial colony algorithm applied to the robot path planning problem, make the robot path planning problem is handled well.
MIMO
- mimo无线通信Alamouti方案，重复码编码方案，迫零接收及匹配接收方案实现的matlab源程序 -Implement a complete MIMO system with different combinations of the following components: (a) Alamouti, repetition code, and V-BLAST (at the transmitter) (b) zero-forcing and MMSE (at the rec
shujufenxi
- 用以计算离散信号的均值，均方根值，方差，峭度和歪度-The mean value of discrete signal to the RMS value, variance, kurtosis and skewness.
airpls
- airpls 自适应迭代重加权惩罚最小二乘 扣除背景,梁逸曾 -airpls for correcting baseline， AdaptiveIterativeRe一weighted PenalizedLeastSquares
chengxu
- 小波变换进行变速箱故障诊断 首先将s1和s2信号时域谱（s1代表维修前的振动信号，s2代表维修后的振动信号），画出来进行对比，会发现s1信号的振动幅值会比较高；然后对s1和s2分别进行小波分解并画出各层的时域谱，只对比s1和s2分后的最高时域谱，s2更加的具有周期性，且幅值较小，s2周期性不够明显，且振动过于密集。分析完时域谱后开始分析频谱，首先对原信号s1和s2fft转换，得到频谱图，如图，然后再对小波分析后高频部分进行fft转换，做出频谱图。对比后我们发现，在f 2375HZ出（也就是齿
ISCST3
- 高斯烟云模型用于空气污染，画出传播的模型-Model Gaussian plume model for air pollution, the spread of the draw
PWM整流仿真
- 三相PWM整流，可以正常使用，如果运行错误，复制到新建模型中运行
APF+SVPWM整流
- 加入APF的三相整流，使用SVPWM，亲试效果可用，使用时注意版本
FM-Modulation
- 这是FM调制MATLAB源码，画出信息信号和已调信号的频谱。-This is the FM modulation MATLAB source, draw the information signal and the signal has been modulated spectrum.
xiebojisuan_0
- 一个谐波计算的m文件，实现谐波的计算，希望对大家有帮助