资源列表
ZF-MMS-BD-SLNR
- 迫零预编码算法 最小均方误差预编码算法 块对角化预编码算法 信号泄露噪声比预编码算法的误码率和系统容量的比较-Forced zero precoding algorithm of minimum mean square error (mse) precoding algorithm block diagonalization precoding algorithm signal leak noise than the precoding algorithm of bit error rate a
spa
- 基于matlab 2014b 的一种spa算法（连续投影算法），本人原本用于做光谱数据的定量分析,寻找特征波长。-Based on matlab 2014b a spa algorithm (continuous projection algorithm), I was originally used for quantitative analysis of spectral data，looking for the Characteristic wavelength.
Detailed_PMSG_one_machine
- 完整的永磁直驱风电系统模型，包括风轮机，发电机，双PWM变流器，控制系统等-Complete permanent magnet direct drive wind power system model, including wind turbines, generators, dual PWM converters, control systems, etc.
Direct-drive-Permanent--Magenet
- 包括风轮机，发电机，双PWM变流器，控制系统等完整的并网永磁直驱风电系统模型，-a complete grid-connected direct-drive wind power system model,including wind turbine, generator, dual PWM converter, control system,
PMSG-connected-to-grid
- 基于双闭环矢量控制的永磁直驱风电系统的并网模型，输出功率和直流电压波形理想-Grid- connected model of permanent magnet direct drive wind power system based on double closed- loop vector control and Output power and DC voltage waveform are ideal
Tabusearch
- 在MATLAB平台，实现利用禁忌搜索算法，解决基站选址问题-In the MATLAB platform, use the so called tabusearch algorithm to solve the problem of secleting the best base station locations
yamsheD-FFT
- 柯林斯公式的D-FFT计算 调入一图像，计算光波通过ABCD系统的衍射场振幅图像-D- FFT Computation of Collins Formula
基于曲线演化的左心室分割
- 基于snake模型和水平集的曲线演化左心室分割，可以获得心室曲线
PMSG_Demo
- 根据永磁同步发电机数学模型搭建的仿真模型，可以用于仿真分析-A simulation model based on mathematical model of permanent magnet synchronous generator
KALMAN-Channel-estimation
- 关于卡尔曼滤波的信道估计的代码 可以参考一下-About Kalman filter channel estimation codes
FOMMC_ESPRIT
- 利用四阶混合平均累积量对色噪声进行去燥，然后用空间旋转不变技术对低频振荡信号进行辨识-The color noise is decontaminated by the fourth-order mixed average cumulant, and then the low frequency oscillation signal is identified by the space rotation constant techniq
contact-region
- 球头刀铣削过程中，刀具球头部分与工件接触区域的计算。-Ball milling cutter head, the cutter head portion and the ball contact area of the workpiece is calculated.