资源列表
KernelSVM
- SVM中常用的核函数，可直接通过调参使用(The common kernel function in SVM can be used directly by adjusting parameter)
AR_BT
- 分别使用AR法和BT法对采样到的序列进行功率谱分析，获得序列的主要频率。文档中的序列和噪声属性可以自行更改。(The AR method and BT method are used to analyze the sequence of the sampled data, and the main frequency of the sequence is obtained. The sequence and noise attributes in the document can be chan
LEM ISAR
- 强力推荐ISAR转台成像程序，发送线性调频波。ISAR成像在进行了平动补偿之后，模型等效为转台模型(The ISAR turntable imaging program is strongly recommended, and the LFM wave is transmitted. After the ISAR imaging is compensated for translation, the model is equivalent to a turntable model)
DFG3
- using matlab to solve the heat transfer problem
msb.tar
- get the msb of a 32bits binary number
rawread
- raw图像读取，用于matlab的一个函数，直接使用，不同raw有所不同，这个转载自网上(Raw image read, used for a function of MATLAB, direct use, different raw different, this reprinted from the Internet)
zhuangjia
- 完成专家系统专家PID控制系统结构图,使用MATLAB进行编程(Complete the structure diagram of expert system expert control system.Programming with MATLAB)
mohu
- 基于智能控制的模糊控制的一个仿真实例，要求用MATLAB进行完成(A simulation example of fuzzy control based on intelligent control, which is required to be completed with MATLAB)
PID控制程序
- 最近学习了关于PID 的控制程序，下面提供程序供大家来参考(We have recently learned a control program for PID. The following program is provided for you to refer to)
Untitled
- 控制器采用二维的模糊控制器，其输入信号偏差为e和偏差的变化为的de，控制对象为时滞对象： ，假设系统给定为阶跃值R=10，系统的初始值R(0)=0。本例采用的是增量控制方法，所以模糊控制器的其输出量为△U。后面经过一个积分环节，就得到了一个控制信号U。E、dE、△U的模糊论域划分为13个档次，论域取为[-10,10]之间。各个论域E, EC和△U的语言变量为{NB， NS，0，PS，PB}。采用两种方法实现pid输出曲线按的模拟。(A two-dimensional fuzzy controll
qpso
- qpso的源码和相关注释，QPSO算法的MATLAB源码，给需要的人，(Global convergence of the PSO algorithm can be used for the development of intelligent computing)
实验
- 提供了一种图像相位恢复算法，此算法为gs算法，本代码为gs算法最基础的代码。(An image phase recovery algorithm is provided. This algorithm is the GS algorithm. This code is the most basic code of the GS algorithm.)