资源列表
MATLAB_JPDA
- JPDA用来进行多目标跟踪的JPDA算法的MATLAB程序包. 跟踪效果还行-JPDA used for multi-target tracking JPDA algorithm MATLAB package tracking performance is also OK
FLUOFIT
- 一个比较成熟的计算荧光寿命的程序.matlab环境.直接使用.-A very good sofware written in matlab, for fluorescence lifetime calculation.
CCITT_CRC16
- CCITT的CRC16代码，自己编写的已通过验证，注意和Matlab的CRC函数有所不同。-This scr ipt calculates the 16-bit ITU-T CRC. The generator polynomial is G(x)=1+ X^5+ X^12+ X^16
chuanshujuzhen_20101130
- 计算随机薄膜厚度的反射率和透射率，利用传输矩阵编写-Random film thickness calculated reflectance and transmittance, written using the transfer matrix
snr
- 计算信噪比，计算公式是信号能量比上噪声能量-SNR Calculation，signal power divide noise power
matlab
- 一本简单介绍蒙特卡洛方法的书籍，非常好，还有源程序！-A brief introduction to Monte Carlo method books,
CGwudian
- 本例用五点差分法求解一个二阶偏微分方程，其间用CG法处理，此实验可分别选取N=4，8，16，32-This example uses a five-point difference method for solving second order partial differential equations, during treatment with CG, were selected for this experiment can be N = 4,8,16,32
smithcontrol
- 先进PID:Smith预估器纯滞后补偿，通过与PID控制器并接，来抵消实测滞后的影响-Advanced PID: Smith Predictor time delay compensation, with the PID controller and then to offset the impact of the measured hysteresis
crc24
- 进行LTE的CRC的添加程序，在lTE系统的链路级仿真中，发端的设计编程。属于LTE CRC附着器。-CRCA，CRCB，LTE
pid2
- PSO优化PID的MATLAB源代码程序-PSO optimization process PID MATLAB source code
pls_toolbox
- pls toolbox for matlab
hengjia
- 计算一个平面桁架结构的总体刚度矩阵，最后以图形形式显示出桁架结构-Calculation of a plane truss structure' s overall stiffness matrix, the last show in graphical form of truss structure