资源列表
FT3
- 此设计主要用于FT3发送编码,符合IEEE60044-8协议-This design is mainly used for FT3 to send coded in line with IEEE60044-8 agreement
windcoefficient
- 用matlab仿真风力发电中风能利用系数和叶尖速比等参数的关系-Relationship with the the matlab simulation wind power wind energy utilization coefficient and tip speed ratio parameter
PV_Grid_System_
- 在PSCAD环境下的建成的光伏并网的仿真源代码,对于光伏并网的仿真研究非常有用-PSCAD environment built photovoltaic grid simulation source code is very useful for photovoltaic grid simulation study
HDC
- GDP32可控源数据编辑软件,可对原始数据进行选择和编辑,频点选取等,为后续反演提供高质量数据体-GDP32 CSAMT data edit
SENKIN
- 化学敏感性分析程序,用来分析影响组分生成的重要化学基元反应机理贡献率-the senkin code is used to analysis the contribution ratio of the elementary reactions to one species
ieee9
- ieee9节点电路,pscad仿真,挺有学习价值的,入门级必看-ieee9 node circuits, pscad simulation, quite the learning value, entry-level must-see
buckboost
- buck/boost双向DCDC变换电路,即可以进行降压也可升压,采用双闭环控制-buck/boost bi-directional DC DC converter circuit, both can also be buck boost, dual loop control
Fig7x19
- matlab simulink 编写的 三相电流滞环控制变流器-matlab simulink
power_3phsignaldq
- 演示使用的power_3phsignaldq离散三相位可编程源代码块生成1 p.u.,正序电压15度。在0.05秒的正序电压增加到1.5 p.u.,在0.1秒的不平衡是由一个0.3 p.u.负序分量相位与30度的引入。正序分量的大小和相位用两种不同的方式进行评估(The power_3phsignaldq demo uses a Discrete Three-Phase Programmable Source block to generate a 1 p.u., 15 degrees posi
飞轮建模
- 用于基本的机械领域的飞轮建模分析,熟悉apdl的基本建模技巧(for modling the flywheel by using the apdl)
MATLAB简化3节点分析
- 简单的三节点系统最优潮流,包含发电机的经济参数,用于OPF计算分析。(Simple three node system optimal power flow, including the generator's economic parameters, is used for OPF calculation analysis.)
Runge-kutta 解决二阶实际问题程序
- C语言编程四阶龙格库塔法解二阶常微分方程(C Language Programming Fourth Order Runge-Kutta Method for Solving Second Order Ordinary Differential Equations)