资源列表
Introduction-protocol-programming
- 通信规约编程入门，方便通信规约编程学习，欢迎使用。-Communication protocol programming started to facilitate communication protocol programmed learning are welcome to use.
mykl
- 蒙特卡罗模拟法，对于5节点系统进行了相关的计算，结果比较理想。-Monte-Carlo simulation
tools_export_bom
- NX二次开发导出BOM表到Excel工具-NX secondary development to export BOM to Excel tool
pitrangle
- APF控制 电压环与电流环串联实现 采用Id Iq电流检测算法-APF Control
SLOPE-stability-analiyze
- 根据边坡已有参数基于极限分析方法,求解边坡稳定性系数Fs.-TO obtain the safety factor of slope
RN8302
- 计量芯片RN8302 底层驱动代码,实现数据读写功能。-RN8302 driver
wind-pitch-control-pscad
- 风力发电机的浆距控制PSCAD仿真模型,模型通过仿真可以看到如何调节风力机的浆距，影响其输出。-pitch angle control for wind energy generation system, PSCAD/EMTDC model
csamt
- 电偶源频率域可控源 CSAMT一维正演程序- CSAMT one dimensional forward procedure
Wind_startup_01
- pscad风机启动模型，风电出口处设置故障，分析有功和无功变化及端电压变化情况-pscad fan start model, wind power at the outlet is set failure, analysis of changes in active and reactive power and terminal voltage changes
runpf
- matpower用牛顿法进行潮流计算源程序-matpower Newton method source
IEEE-14-bus-with-matlab
- IEEE14节点系统的标准的 matlab 编程设计。估算其状态值，如各节点的电压和相角值。-IEEE forteen bus processing with matlab