资源列表
hysteresis-comparator
- PSIM中滞环控制器，环宽、频率、占空比等等可以自己设定。-hysteresis comparator
ade7753.c
- source code for drive ade7753. ade7753.c
Untitled6
- 以改变输入回路的高端谐振频率，使之始终低于本机振荡频率465kHz。所以微调电容C主要用于调整波段高端的接收灵敏度。-To change the resonant frequency of the input circuit of the high-end, so that is always lower than the local oscillation frequency 465kHz. It is mainly used to adjust the trimmer capacitor C
Main_Volterra_MultiStepPred
- 风电纵向出力混沌预测，对研究风电出力预测有一定意义-Chaotic prediction vertical wind power, wind power output prediction has certain significance for research
active
- matlab函数文件 输入：原始测井曲线 输出：矩形化测井曲线 功能：利用活度函数法将原始测井曲线转化为矩形化测井曲线-a matlab function file input:raw log curves output:blocked log curves function convert raw log curves to blocked log curves based on active function method
guokai
- 能够对储能系统的内容参数做出系统分析，运用了最小二乘法-Can make a systematic analysis of the contents of the parameter storage system, using the least squares method
power_flow
- 基于牛顿-拉夫逊算法的电力系统潮流计算，简单易懂。-The power flow calculation based on Newton-Raphson algorithm, which is easy to understand.
Gibbs
- 地震信号处理中会产生吉布斯现象，这个程序可以帮助认识这种现象。-Seismic signal processing will produce Gibbs phenomenon, this program can help understanding this phenomenon.
AVO
- AVO地震响应，描述反射系数随炮检距的变化，为砂泥岩含气模型，属于第一类AVO-AVO seismic response, describing the reflection coefficient variation with offset for sand shale gas models belonging to the first category AVO
15pianyi
- 简单的偏移程序，这段代码只实现了15度的情况。代码只是给初学者参考，其他不足地方请多包涵。最后形成的二进制文件“15chafen”可以用来成图。-Simple offset program, this code only achieved 15 degrees. Code just for beginners reference, other deficiencies places vexed. Binaries final form 15chafen can be used to map.
PreMultiStack
- 地震资料解释 叠前多角度组合流体识别-Prestacking Multi-angle Combination fluid identification
CHAOLIU3
- 用于牛顿拉弗逊法的实际应用的用MATLAB编写的潮流计算程序-Used for Newton laffer method MATLAB prepared by the tide of the practical application of the application