资源列表
Exercise6
- ssd4 exercise 6 from icarnegie.com
driver
- 在CVI环境中，编写PCI板卡的驱动程序-PCI driver CVI
room
- 完成对室内温度的控制，根据不同的室内温度选择不同的取暖器档位的仿真-Indoor temperature control
labview-PID
- 基于PID控制的labview程序，适用于磁悬浮球等实验和毕业设计等用途。-pid control in labview
wendukongzhi
- 随机产生温度并计算超过设置的温度上限的次数并产生声音报警-Randomly generated temperature and calculate the maximum temperature exceeds the set number of times and generates an audible alarm
five
- 利用移位寄存器实现动态曲线的显示。其中刷新下一条曲线的时候，上一条曲线依旧保留在图中，不会被覆盖。-Shift register and display the dynamic curve. Wherein when refresh curve, curve still retained in the figure, and will not be overwritten.
laser_full_-config
- 初始化可调谐激光器，然后设置激光器的各个参数。-set laser
lisaru
- 绘制李萨如图形,采用labview绘制李萨如图形！-Draw Lissajous figures
scope
- 用labview编写的数字示波器，可采集波形，并进行滤波、回放及保存功能！-LabVIEW preparation of the digital oscilloscope, waveform acquisition and filtering, playback and save!
time
- this a watch that is very good-this is a watch that is very very good
labview_programs
- Basic Serial Write and Read.
pmd
- 跑马灯，程序功能就是实现让灯依次亮，循环不停-Marquee, the program function is to realize the lights were bright, the cycle goes on