资源列表
Extract-the-envelope
- 用hilbert算法对信号的包络线进行提取，既有单一包络线，也有原始信号与包络线的图像。-Algorithm using hilbert envelope signal extraction, both single envelope, there are images of the original signal and the envelope.
trigger-counter
- 设置触发门限，计算波形信号穿过门限的次数。-Set the trigger threshold, the frequency of the signal passing through the threshold calculations.
peak-and-trough-of-the-wave
- 设置一阀值，检测波形信号的波峰、波谷数目。-Providing a threshold, the peak detection signal of the waveform, the number of troughs.
WT-detect
- 对原始波形进行小波变换，分别显示原始波形幅度谱与小波变换后的幅度谱之间差异。-Wavelet transform of the original waveform, shows the difference between the amplitude spectrum of the original waveform amplitude spectrum and wavelet transform, respectively.
deferent-of-FFT-FRF-and-FM
- 显示了对labview中FFT频谱、频响、和频谱测量三个vi的区别。-Shows the difference for labview in FFT spectrum, frequency response, and spectral measurements three of vi.
PSD-and-PS
- 分析测量信号的FFT功率谱及功率谱密度，比较两者之间的差异-FFT power spectrum and power spectral density analysis comparing the measured signal difference between the two,
UART
- labview中的串口驱动程序,用于实现计算机与其他串口设备连接-Serial port driver in labview, is used to implement computer connected to the other serial devices
virtual-software
- 在学习labview串口时，可以帮助你在没有串口数据线的时候，检验你程序运行的结果-When learning labview serial port, can help you in no serial data line when running your test results
201451913558886
- 学生成绩自动统计，简介，方便，高效，简单-Automatic statistics student achievement
ReadText
- 通过NI视觉模块读取字符的示例(OCR)-OCR example
YC92B_Serial_Communication
- labview control equipment demo
NI_DAQ_0
- 使用NI-pcie办卡在visual studio下制作的产生信号的dll工程，适合学习这一块的同学。-Use NI-pcie do card produced under visual studio dll project generates a signal for students to learn this piece.