资源列表
prog3
- signal processin matlab m code
prog5
- signal processin matlab m code
shangweiji
- 关于LabVIEW的上位机，主要用于与dsp过于SCI通信。-About LabVIEW host computer is mainly used for communication with the dsp too SCI.
fibonacci-number-sequence
- 产生指定数目的斐波那契数列。输入想产生的数字个数，则会输出相应的斐波那契数列，同时绘制数列曲线图。-Fibonacci generating a specified number of sequence. Enter the number of digits to produce, it will output the corresponding Fibonacci series, at the same time sequence graph drawing.
2
- 基于labview开发环境的 模拟温度监测程序-Labview simulation-based temperature monitoring program development environment
White-Noise-generator
- USRP 210 2920 2930 white noise generator (radio jammer)
step-Noise-generator
- USRP 210 2920 2930 step noise generator (GSM, 3G, 4G jammer) need powerfull PC
FM-Radio-TX-2
- USRP N210 2920 2930 modified FM radio transmitter with different FM modes
SSDrecordUSRP
- USRP N210 2920 2930 tuned-up high speed radio recorder to SSD disk, up to 50MHz of bandwidth, need extremly powerfull computer
SSDplaybackUSRP
- USRP N210 2920 2930 tuned-up high speed radio payback from SSD disk, up to 50MHz of bandwidth, need extremly powerfull computer
Simultaneous-Tx-Rx
- USRP N210 2920 2930 Simultaneous transmitter and receiver in one USRP device, remember that the bandwidth is reduced to two halves due to cable throughtput
resonant-frequency-testing
- 通过labview控制信号发生器和锁相放大器进行共振频率检测的程序。freq test.vi实现信号发生器的频率扫描，lockin test.vi 实现锁相放大器的参数设定，数据采集.vi实现锁相数据的采集，waveform arrays to file实现波形数据到文件数据的转换。共振频率测试.vi实现晶振等共振频率的测试-Resonance frequency detection procedures performed by labview control signal generator