资源列表
automatic
- labview与thorlabs的移动平台进行通信达成自动控制-automatic movation
TDC-GP2-MSP430F413
- gp21 与430单片机程序（测评过完全可以用）-gp21 and 430
sensor-analysis
- 这是一个仪器性能分析程序，对一组数据进行拟合，分别计算仪器的线性度、迟滞、重复性、最大值、最小值。-This is an instrument performance analysis program to fit a set of data were calculated instrument linearity, hysteresis, repeatability, maximum, minimum.
Calibration
- 通过实测值与理论值实现线性校准，左侧输入理论值，中间输入实际值，右侧限制线性误差值- Through the measured value and theoretical value of linear calibration, the left input theory, the actual value of the middle input, the right side of the linear error limit
labview
- 灯泡采集系统模块，采用labview语言编写。-Bulbs acquisition system module using LabVIEW language.
IMAN-Find-Edge(Project)
- labview 利用imaq函数寻找灰阶图像中黑白交界边缘-Labview use the function of imaq to find the edge of the image
Synchronize-C-Analog-Input
- Combine CAN Communication Logging With Other IO
dianzihuaibiao
- 基于labview的简单电子怀表，实现了简单的计时功能，供初步学习！-Labview is based on a simple electronic watch!
CloseAppWin
- LabVIEW语言，关于LabVIEW关闭Window应用程序-How to use LabVIEW to close Application Window
new_struct
- Labview状态机入门很好的例子，初学者很容易理解-Labview for atate machine
signal-acquisition
- 利用随机数发生器仿真一个0到5V的采样信号，每200ms采一个点，共采集50个点，再增加1路电压信号采集，此路电压信号的范围为5到10V，采样间隔是50ms，共采100个点，采集完后一次性显示在Waveform Graph上。-Simulation using a random number generator with a 0 to 5V signal sampled every 200ms adopt a point of collecting 50 points, and then add
write-binary-file-advanced
- write binary file advanced