资源列表
milling--interface
- 旋转式铣削扭矩数据采集系统的Labview程序,有各种功能-Labview for milling tool interface
xunixinhaofashengqi
- 具有基本波形输出,正弦波、方波、锯齿波、矩形波。并且具有调节占空比的功能,另外还能输出任意输入的公式波形,并且可以实时显示时间,具有登陆验证功能,登陆用户名是仪电,密码是123-With the basic waveform output, sine wave, square wave, sawtooth wave, rectangular wave. And has the function of adjusting the duty cycle, another formula can ou
TEST
- 设置继电器动作时间,控制下位机继电器的动作时间以及动作次数。记录和测试继电器是否正常。-Set the relay action time, control the lower machine relay action time and the number of actions. Record and test the relay is normal.
data-collection
- 数据采集系统,用于文件的数据采集和简单处理-data collection
Virtual-signal-generator
- 基于Labwindows/CVI的虚拟信号发生器-Virtual signal generator based on Labwindows/CVI
Counter---Count-Edges
- 采集卡脉冲边沿计数,并计算脉冲频率,以图表形式显示-The pulse edge count capture card, and calculate the pulse frequency
Peak_power_measure
- 使用 labview 编写的控制界面,控制实验室的光谱仪,测量峰值的光功率-spectrum controller
Tank-Simulation
- 水箱模拟的llb文件,可以模拟水箱的温度,水位,平均值等-Tank simulation llb file, you can simulate the temperature of the tank, water level, average, etc.
labviewConvolution-decode-
- 本程序注重实现卷积编码以及译码的实现,简单明了-The program focused on realization of convolution coding and decoding implementations, simple
Exercise-4-2b-Challenge
- labview 完成波形数据采集,并保存到文件-labview data acquire
gugu76860
- 此源程序为用Labview程序编制的,针对采集信号的功率进行分析。。(This source program is compiled by Labview program, and the power of the collected signals is analyzed..)
AI+AO
- 基于LABVIEW软件采集电压电流信号,运用DAQmx建立任务(Acquisition of voltage and current signals)