资源列表
NI-VISA-USB-driver
- 可以通过向导自动开发USB驱动，Labview可以进一步直接调用USB设备。-Wizard automatically developed by the USB driver, Labview can further direct calls USB device.
saopin
- 产生正弦信号的扫频信号，频率可调，可作为激励信号-Sweep signal generated sinusoidal signal frequency is adjustable, can be used as the excitation signal
自动获取串口
- labview 自动获取串口号，两种方法(LabVIEW automatically gets serial number)
niScope EX Configured Acquisition Live
- 基于labview NI-SCOPE的数据采集，NI-SCOPE(Data acquisition based on LabVIEW NI-SCOPE)
IP-address-Xcontrol
- 在labview中实现的Xcontrol控件，可直接进行ip地址的输入。-Using labview to input ip address by Xcontrol userdef control.
DAQ
- 多通道的选择、信号类型的设置、数据保存和回放-The choice of multi-channel, signal type setting, data storage and playback
resonant-frequency-testing
- 通过labview控制信号发生器和锁相放大器进行共振频率检测的程序。freq test.vi实现信号发生器的频率扫描，lockin test.vi 实现锁相放大器的参数设定，数据采集.vi实现锁相数据的采集，waveform arrays to file实现波形数据到文件数据的转换。共振频率测试.vi实现晶振等共振频率的测试-Resonance frequency detection procedures performed by labview control signal generator
25-Phone-Simulator
- labview example-photo simulator
2016NIOpcServer_downloader
- labviewDSC使用OPC,可以连接PLC-LABVIEW DSC
LV1M18_Case-Structures
- Labview training file
2017010716500
- lanbiew串口通信程序，实现PC与51单片机串口通信-Lanbiew serial communication program, PC and 51 single-chip serial communication
time
- “校准时间”文件夹的“图15-11-校准计算机系统时间.vi”可以接收GPS卫星时间信号并用其校准计算机系统时间。-Figure 15-11- Calibrate Computer System Time .vi in the Calibration Time folder can receive GPS satellite time signals and use them to calibrate computer system time.