Comments :

(1) Full Duplex

(2) Tested from 1200 to 9600 Baud( @ 8 Mhz )

(3) Tested from 1200 to 19200 Baud(@ 16 & 20 Mhz)



The User gets a total time as specified by the User Cycles

in the table ( or from equations ). The user routine has to

exactly use up this amount of time. After this time the User

routine has to give up the control to the Operating System.

If less than 52 uS is used, then the user should wait in a

delay loop, until exactly 52 uS.-Comments :

　　　　　　　　(1) Full Duplex

　　　　　　　　(2) Tested from 1200 to 9600 Baud( @ 8 Mhz )

　　　　　　　　(3) Tested from 1200 to 19200 Baud(@ 16 & 20 Mhz)



　　　　The User gets a total time as specified by the User Cycles

　　　　in the table ( or from equations ). The user routine has to

　　　　exactly use up this amount of time. After this time the User

　　　　routine has to give up the control to the Operating System.

　　　　If less than 52 uS is used, then the user should wait in a

　　　　delay loop, until exactly 52 uS.