This example program shows how to configure and use the A/D Converter of the following microcontroller:



STMicroelectronics ST10F166

After configuring the A/D, the program reads the A/D result and outputs the converted value using the serial port.



To run this program...



Build the project (Project Menu, Build Target)

Start the debugger (Debug Menu, Start/Stop Debug Session)

View the Serial Window (View Menu, Serial Window #1)

View the A/D converter peripheral (Peripheral Menu, A/D Converter)

Run the program (Debug Menu, Go)

A debug scr ipt (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change.



Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.-This example shows how to program configur e and use the A / D Converter of the following MICR ocontroller : STMicroelectronics ST10F166 After configuri ng the A / D, the program reads the A / D and outputs the result converted value using the serial port. To run th Build program ... is the project (Project Menu, Build Target) Start the debugger (Debug Menu, Start / Stop Debug Session) View the Serial Wind ow (View Menu, Serial Window # 1) View the A / D converter Periph General (Peripheral Menu, A / D Converter) Run the program (Debug Menu, Go) A debug scr ipt (debug.ini) creates buttons that set different analog values in A / D channel s. As the program runs, you will see the A / D input and output change. Oth er buttons create signals that generate sine wa ve or sawtooth patterns as anal