将无线接收模块按照脚位对应插入学习板无线插座注意，不要插错，否则会损坏模块学习板学习板处于正常工作状态D3，D2，D1，D0 ，LED灯亮起，将程序tanst.hex 下载 到学习板程序在配套光盘HZC51学习板使用教程HZC51学习板实验程序无线遥控程序无线遥控里面，下载完后，数码管显示0000按遥控发射器A键，此时遥控器红灯亮起，并发出编码信号，学习板，收到信号并解码并驱动数码管显示4000分别按遥控器B，D，C键，学习板分别显示此遥控器发射距离开阔地可达到100米-The wireless receiver module in accordance with the pin into the learning board corresponding to the wireless socket careful not to plug the wrong, otherwise it will damage the module learning board J7, J8, J13, J18 jumper plug, learning board in normal working condition, when D3, D2 , D1, D0, LED lights, the program downloaded to the learning board tanst.hex program in supporting the CD HZC51 Learning Board Tutorial HZC51 experimental procedure learning board wireless remote control wireless remote control program which, downloaded, by 0000 digital display remote control transmitter A key device, then the red light remote control and send coded signals, study board, receive and decode the signal and drive the digital display on the remote control 4000, respectively, B, D, C key, learning remote control panels are shown the emission distance of up to 100 meters open ground