1.这个软件可以将一幅BMP图形转换为PCB格式。

2.首先制作一幅 BMP图形，把你需要的汉字或记号包含在内。然后运行本软件，

按下“文件”，调入图形。在“参数”中设置“层”与“线宽”，最后，按下

“转换”就可以了。

3.BMP图形最好是单色的。其实，程序只识别黑色，对其它颜色均不做处理。如

果还要一些特殊效果，请用其它软件完成。

4.制作出来的PCB板大小是BMP图形的大小乘以线宽，单位是mil(100mil=2.54mm)

5.BMP图形的大小不要太大，以免产生的PCB文件过大。一般来说，在200x200以

内比较合适。-1. The software can be a BMP graphics format conversion to the PCB. 2. First produced a BMP graphics, you need to mark or the Chinese characters included. Then run the software, press the "paper" into a graphic. "Parameters" set "layer" and "width" Finally, press the "conversion" on it. 3.BMP monochrome graphics is the best. In fact, the procedure to identify black, the other colors do not handle. If they have some special effect, use other software to complete. 4. Production of PCB size of the BMP graphics to the Oaths linewidth, yes mil units (100mil = 2.54mm) 5.BMP image size should not be too high. to avoid the PCB was too big. Generally speaking, the more appropriate within 200x200.