搜索资源列表
fft
- FPGA控制串行AD(AD0804),状态机实现,可以根据该程序实现数字电压计,数字温度计的设计-FPGA serial control AD (AD0804), state machine to achieve, you can program according to the number of voltage, the digital thermometer design
AD9512_VHDL
- FPGA通过SPI总线控制Analog公司的射频时钟分配芯片的程序,在需要用到高速时钟(GHz)的电路中经常采用,比如数据采集卡及信号回放卡中会经常用到该功能,已经在产品中得到验证,工作稳定。-The VHDL code of controlling AD9512 of Analog Device
fpga-pulse_sequence
- pulse_sequence.vhd 并行脉冲控制器 light.vhd.vhd 交通脉冲控制器 division1.vhd 电压脉冲控制器中的分频 ad.vhd 电压脉冲控制器中的A/D控制 code.vhd 电压脉冲控制器中的脉冲运算模块 voltage2.bdf 电压脉冲控制系统-pulse_sequence.vhd pulse controller parallel light.vhd.vhd traffic controller division1.vhd puls
FPGA_AD
- 基于Altera的FPGA开发的基于FPGA的AD转换功能,完全通过验证。-Altera s FPGA-based development of FPGA-based AD conversion function, fully validated.
r_w_flash
- FPGA高速完成AD采集回来的数据进行高速读写FLASH存储-AD Acquisition completion of FPGA high-speed data back to high-speed read and write FLASH memory
AIC
- 使用FPGA/CPLD设置语音AD、DA转换芯片AIC23,FPGA/CPLD系统时钟为24.576MHz 1、AIC系统时钟为12.288MHz,SPI时钟为6.144MHz 2、AIC处于主控模式 3、input bit length 16bit output bit length 16bit MSB first 4、帧同步在96KHz-The use of FPGA/CPLD set voice AD, DA conversion chip AIC23, FPGA/
LVDS_DDR_List_FPGA2
- FPGA芯片与ADI公司的AD9779之间的通信,总共有四个通道,68对LVDS,采样时钟是122.88MHz-FPGA chips ADI' s AD9779 and communication between, a total of four channels, 68 pairs of LVDS, the sampling clock is 122.88MHz
Simulate
- FPGA控制AD逐点采集信号,并将AD转换后的数据串行发送出去。-FPGA to control the signal sampling point by point AD, AD conversion and serial data sent.
daima
- 状态机控制AD转换模块 该模块主要实现对MAX197的控制:根据设计需要对芯片进行初始化(包括写控制字选择输入电压值范围、选择通道以及工作模式),并把通道数送指示灯显示以及用键盘控制通道号(按一下,通道号加1,同时点亮相应的指示灯,循环使用个通道);控制状态机的工作时序,并置两次采集到的数据为12位数据输出,并经过锁存进程来锁存数据,最后从锁存器中把输出数据-The state machine controls AD and changes the module this module ma
DVDT_MORE
- 基于FPGA有限状态机的数据采集系统,实现对高速AD转换的控制。-FPGA-based finite state machine of the data acquisition system for high-speed AD conversion control.
HighSpeedAD
- 基于FPGA数据采集系统,用VHDL语言描述,实现对高速AD转换的控制。-FPGA-based data acquisition system, described by VHDL language to realize high-speed AD conversion control.
EP1C3_12_7_SPCTR
- 基于FPGA的信号采集及频谱分析,用VHDL编写,压缩包里是Quartus下的工程。AD采样用状态机实现,并存入LPM_RAM。设计了一个UART模块(也是状态机实现的),可将数据发到PC机上。-FPGA-based signal acquisition and spectral analysis, prepared with VHDL, Quartus compression bag is the next project. AD sampling state machine used to
SDRAMVerilogHDL
- FPGA控制串行AD(AD0804),状态机实现,可以根据该程序实现数字电压计,数字温度计的设计-FPGA serial control AD (AD0804), state machine to achieve, you can program according to the number of voltage, the digital thermometer design
200M_DA_AD
- 自己编的,用FPGA实现软件DDS调幅。编程语言是VHDL。拿出来相互学习一下。-Own, and with FPGA AM DDS software. Programming language is VHDL. Look out to learn from each other.
ad7304
- a program for AD-Wandler ad7304 in VHDL-Language
ADPCM
- APPCM算法和AD/DA芯片驱动在CPLD中的实现,已在实际硬件中测试OK,quartus2环境-APPCM algorithm and AD/DA chip in the drive to achieve in the CPLD has been tested in actual hardware OK, quartus2 environment
20090903FPGA
- 传统的波形发生器采用模拟技术的方法,这种方法构成的波形发生器电路结构复杂,仅能产生正弦波、方波、锯齿波和三角波等几种简单波形。而现在在高科技领域,我们需要的可能是一些任意波形,如在保密雷达发波等军事方面和地震波形、汽车碰撞波形等模拟仿真应用方面。任意波形发生器现在被广泛用于自动控制系统、振动激励、仪器仪表领域。我国目前在这方面还比较落后,特别是在用DDS技术实现任意波形发生器方面。本课题我们打算用DDS技术基于FPGA核心板设计一个任意波形发生器。该仪器我们用LabVIEW来写的控制面板实现与F
81404622Released-FPGA-CODE-AD9289-RevD
- 直接用FPGA实现AD转换,方便快捷,不需要额外的接线-It s very easy to use AD through FPGA
ADS7852
- FPGA采用VHDL语言驱动ADS7852的程序,-FPGA and ADS7852
oscillograph
- 用VHDL编写的oscillograph数字部分源代码,在Altera FPGA上跑通。直接把模拟部分输入输出AD,DA信号接入本模块即可。-Digital oscillograph with the written part of the VHDL source code, in the Altera FPGA on the run-pass. Directly to the analog input and output AD, DA signal can access this modul