搜索资源列表
步进电机驱动
- 提供的程序是供四相步进电机使用。本实验使用的步进电机用直流+12V电压，电机线圈由A、B、C、D四相组成。 2. 驱动方式为四相单四拍方式,各线圈通电顺序如下表。表中首先向A相线圈输入驱动电流，接着向B，C，D线圈通电，最后又返回到A相线圈驱动，按这种顺序轮流切换，电机轴按顺时针方向旋转。若通电顺序相反，则电机轴按逆时针方向旋转。-provide for the procedures of the four-phase stepper motor use. This experiment use
stepmotor
- 用M16驱动步进电机 ,实现三种驱动方式: 单四拍驱动、双四拍驱动、单双八拍驱动
stepmotor
- 用M16驱动步进电机 实现三种驱动方式 单四拍驱动、双四拍驱动 单双八拍驱动
M8Driver
- 五相步进电机环形分配驱动程序。稍加修改也可用于两相四拍和三相六拍步进电机驱动。-step Motor Driver。
bjdj
- 51驱动步进电机的多种方式，双四拍，单四拍，单双八拍，根据自己的需要调整跳转即可。非常适用。-Stepper motor driver 51 a variety of ways, dual four-shot, single four-shot, single-and double-8 film, according to their need to adjust Jump to. Very applicable.
Step_Motor
- 基于F149单片机的二相四拍步进电机驱动程序-F149-based MCU two-phase stepper motor driver shot four
bjdj
- 步进电机驱动程序，正反转，加减速等，单八拍，双四拍。-stepper motor stepping motor pulse motor step motor
454546565
- 通过本例程了解步进马达使用及驱动程序编写双四拍工作式： AB-BC-CD-DA (即一个脉冲,转 7.5 度) -Stepper motor through this routine about the use and preparation of double four drivers work type: AB-BC-CD-DA (that is, a pulse, switch to 7.5 degrees)
AVR_Stepper
- 基于atmega16l单片机开发四相八拍步进电机驱动，步进电机带64倍降速，程序在8Mhz晶振下调试通过。-Four-phase development based on atmega16l MCU shot eight stepper motor driver, stepper motor with 64 times the deceleration, the program to debug through the 8Mhz crystal.
demoSTEP
- 这是一个使用单片机通过NUL2003驱动步进电机程序. 步进电机: 5伏,500MA/STEP,四限四拍. 将步进电机的A B C D四个绕组连接到 S51E板"步进电机"的A,B,C,D,将公用抽头并接在VCC上. 将"控制输入口"的A B C D 接焊盘 P2.3,P2.2,P2.1,P2.0. 将P2.3-P2.0跳帽置焊盘位. -english
BJDJ
- 单片机通过NUL2003驱动步进电机程序. 步进电机: 5伏,500MA/STEP,四限四拍.-MCU through NUL2003 drive stepper motor program. Stepper motor: 5 V, 500MA/STEP, four limit four beats.
aaa
- 本文介绍了两相四拍混合式步进电机的工作原理及其磁网络模型，推 导了步进电机的动态方程。分析了两种细分驱动方法:等电流法和电流 矢量法恒幅均匀旋转法，提出了基于单片机控制的PWM电流矢量恒幅 均匀旋转的细分驱动技术，实现了步进电机32细分驱动。-so much,so nice.
bujindianji
- avr单片机扩展，步进电机的驱动程序，采用单四拍驱动-avr microcontroller expansion, the stepper motor driver
MADA
- //DMAVR-128的步进电机驱动程序 //步进电机为四相八拍驱动方式，额定电压5V,ABCD对应PB1~PB4 //初始设置为12小时制，下午时间-//DMAVR-128 stepper motor driver// stepper motor for the four-phase eight-beat-driven approach, the rated voltage of 5V, ABCD corresponds to the PB1 ~ PB4// initially set
STEPMOTOR_L298DRVtest
- 用于L298N驱动步进电机，本代码用于步进电机反转两相四拍。-For L298N drive stepper motor, and the code for two-phase stepper motor reversal shot.
STEPMOTOR_L298DRVtest
- 用于L298N驱动控制步进电机，本代码是其中的两项四拍程序。-For L298N drive control stepper motor, the code is one of the two four-beat program.
C
- 此程序为步进马达的运动驱动程序，含5中运动模式：单双八拍1、单双八拍2、加减速、双四拍、正反转-Procedures for the movement of the stepper motor driver, with 5 in sports mode: single and double eight beats 1, odd and even eight-shot, acceleration and deceleration, dual four-beat, positive
motor
- 两相四线步进电机 驱动控制加速减速 正反转 四拍 八拍-Accelerated reversing two-phase four-wire stepper motor drive control
03MOS管驱动步进电机实验
- 03MOS管驱动步进电机实验c语言编程，两相八线步进电机按四相接线，采用MOS管驱动，分别按照单双八拍和双四拍方式驱动 请按ESC退出程序，若直接点差号关闭程序MOS管持续导通易烧毁器件(03MOS tube drive stepper motor experiment, C programming language)
51驱动源码
- 51驱动步进电机，两相四拍。大家共同学习，共同进步。(51 two-phase stepper motor driver.)